125992512.qxd 14/07/2004 17:09 Pagina 10
Operating sequence
Before using your tumble dryer for the first time, we8. If the laundry is not removed at the end of the
recommend to place a few damp cloths inside thecycle, the dryer performs an anti-creasing
appliance and dry for 30 minutes.phase and an acoustic signal can be heard
There may be dust inside a brand new tumble dryer. (duration: 30 minutes maximum).
If you do not remove the laundry, the dryer will stop
Dryingautomatically at the end of the anti-creasing phase.
Lights END, CLOGGED FILTERS and FULL
1. Connect the appliance.TANK remain lit and the buzzer sounds for 2
minutes.
2. Open the door.9. Turn the programme selector dial to ?O?; all the
lights go out. The appliance is switched off.
Remove the laundry.
If you open and then close the door before
turning the selector dial to ?O? all the lights
corresponding to the phases making up the
performed programme come on.
After each use
3. Load the items one at a time, shaking them out
loosely. Clean the filters (see page 11).
Empty the water reservoir (see page 12).
4. Close the door. Check the laundry does not get
caught between the door and filter.
5. Select the drying programme or time. The lightsImportant!
DRYING, COOLING and END come on.If the drying program has to be stopped before it
6. If required, press the LOW TEMPERATUREreaches cycle end, we recommend you turn the
button and/or the NO BUZZER button or theprogram selector dial to the cooling position and
QUICK button.wait till the end of its cooling phase before removing
7. Press the START/PAUSE button: thethe garments. This will avoid the build-up of heat
inside the appliance. To do this first turn the dial to
corresponding light stops flashing and drying?0? and then to the cooling program, depress
starts. Only the DRYING light remains lit.Start/Pause button.
If the programme selector dial is turned to
another position, when the machine is running,
the buzzer will sound (if the NO BUZZER optionModifying the programme
has not been selected) and the programmeTo change a programme which is running, first
phase indicator lights will flash.cancel it by turning the programme selector dial to
The drum turns alternately in both directions?O?. Select the new programme and press the
during drying.START/PAUSE button.
All drying programmes end with a 10 minute
cooling phase (COOLING light is on).
You may remove the laundry after this phase.
The lights END, CLOGGED FILTERS and FULL
TANK illuminate and the buzzer sounds.
10 |
ACEC
