125980811 gb.qxp 2005-02-23 09:51 Page 11
Operating sequence
Before using your tumble dryer for the first time, wecooling phase (light ?Afkoelen? (?Cooling?) is on).
ENGLISH
recommend to place a few damp cloths inside the
You may remove the laundry after this phase.
appliance and dry for 30 minutes.
There may be dust inside a brand new tumble dryer. The lights ?Einde? (?End?), ?Pluizenfilters?
(?Filter cleaning?) and ?Waterhouder? (?Water
reservoir full?) illuminate.
Drying
The display shows a static zero and the buzzer sounds.
1. Connect the appliance.
9. If the laundry is not removed at the end of the
2. Open the door (see picture).
cycle, the dryer performs an anti-creasing
phase (duration: 30 minutes maximum).
If you do not remove the laundry, the dryer will stop
automatically at the end of the anti-creasing phase.
Lights ?Einde? (?End?), ?Pluizenfilters? (?Filter
cleaning?) and ?Waterhouder? (?Water reservoir
full?) remain lit and the buzzer sounds every 10
seconds for 2 minutes.
The light of the Start/Ppauze button goes off and
a flashing zero appears on the display.
3. Load the items one at a time, shaking them out
10. Turn the programme selector dial to ?UIT?; all
loosely.
the lights go out. The appliance is switched off.
4. Close the door. Please check the laundry does
Remove the laundry.
not get caught between the door and filter.
If you open and then close the door before
5. Select the drying programme or time. The lights
turning the selector dial to ?UIT? all the lights
?Drogen? (?Drying?), ?Afkoelen? (?Cooling?) and
corresponding to the phases making up the
?Einde? (?End?)come on. The light of the
performed programme come on and the
StartPpauze button flashes and the display
display shows the duration of the programme.
shows the duration of the programme.
6. If required, press the ?Lage temp.? (?Low
After each use
temperature?) button and/or the ?Zoemer uit?
(?Buzzer OFF?) button or the ?Kort? (?Quick Clean the filters (see page 13).
drying?) button. Empty the water reservoir (see page 14).
Important!
7. Select the ?Startuistel? (?Delayed Start?)if
required. The selected delay appears on theIf the drying programme has to be stopped before it
display for 2 seconds, then the duration of thereaches the end, we recommend that you turn the
selected programme is displayed.programme selector dial to position ?Afkoelen?
8. Press the ?Start/Puaze? (?Start/Pause?) button:(?Cooling?) and wait until the end of this cooling
phase before removing the laundry. This will avoid a
the corresponding light stops flashing and drying
build-up of heat inside the appliance.To do this first
starts. Only the light ?Drogen? (?Drying?)
turn the dial to ?UIT? and then to ?Afkoelen?
remains lit. If you have selected the delayed
(?Cooling?) and depress Start/Pauze button
start, the machine begins its countdown..
If the programme selector dial is turned to another
position, when the machine is running, the buzzerModifying the programme
will sound, the programme phase indicator lights
To change a programme which is running, first
will flash and Err appears on the display.
cancel it by turning the programme selector dial to
The drum turns alternately in both directions
?UIT?. Select the new programme and press the
during drying.
Start/Pauze button.
All drying programmes end with a 10 minute
11 |
ACEC
