Installation
The oven must be installed according to theThis oven must be installed according to
instructions supplied.standards and regulation currently in force.
Technical DataHeating elements rating
Oven element1,880 W
Dimensions of recess
Top element835 W
Height580 mm.
Bottom element1,045 W
Width560-570 mm.
Depth550 mm.Convection element2,090 W
Grill element1,830 W
Dimensions of the oven cavityDouble Grill element2,665 W
Height325 mm.Pizza Oven Function3,135 W
Width420 mm.Convection Fan30 W
Depth390 mm.
Oven Light15 W
Oven capacity53 litres
Cooling Fan25 W
Total Rating3,200 W
Supply voltage (50 Hz)230-240 V
Electrical Connection
The oven is designed to be connected to 230 -240 V
(50Hz) electricity supply.
The oven has an easily accessible terminal block which
is marked as follows.
Letter LLive terminal
Letter NNeutral terminal
Earth
The cable used (of the types: H05 V2V2-F T90, H05 BB-
2
F T90) must have a min. cross section of 1.5 mm.
In order to connect it to the oven it is necessary to
remove the hatch at the back of the oven to reach the
terminal block.
For direct connection to the mains supply a two pole
switch with a minimum rating of 13 A and a minimum
distance of 3 mm between its contacts must be fitted
between the supply and appliance.
This switch must not break the yellow/green earth cable
at any point.
The appliance must be earthed
Important
After installation and connecting, the cable must be
placed so that is cannot at any point reach a tempera-
ture more than 50°C above the ambient temperature.
Before the appliance is connected check that:
- the main fuse and the domestic installation can
support the load;
- the power supply is properly earthed;
- the double pole switch used to connect the appliance
to the supply is easily accessible after installation.
23 |
ACEC
