CARE AND CLEANING
CLEANING INSIDE THE OVEN/GRILL
BEFORE CLEANING THE APPLIANCE
ALWAYS ALLOW THE COOLING FAN TOThe Stayclean surface inside the Oven should not be
COOL THE APPLIANCE DOWN BEFOREcleaned manually. See page 31 'Care of Stayclean
Surfaces'.
SWITCHING OFF THE ELECTRICITY
SUPPLY.The vitreous enamel oven base can be cleaned using
normal oven cleaners or aerosol oven cleaners with
CLEANING MATERIALScare. Ensure that the manufacturers instructions are
Before using any cleaning materials on yourfollowed and that all parts are well rinsed afterwards.
appliance, check that they are suitable and that theirAerosol cleaners must not be used on Stayclean
use is recommended by the manufacturer.surfaces and must not come into contact with
elements or the door seal as this may cause
Cleaners that contain bleach should NOT be used asdamage.
they may dull the surface finishes. Harsh abrasives
should also be avoided.
CLEANING THE OUTSIDE OF THE
APPLIANCE
DO NOT use abrasive cleaning materials e.g. Hob
Brite, Brillo pads or scourers on painted or printed
finishes as damage may occur. Regularly wipe over
the control panel and oven door using a soft cloth
and hot water to which a little washing up liquid has
been added. . Any spillage on the stainless steel
finish must be wiped off immediately.
Stainless Steel cream cleaners are abrasive and
should be avoided as they may dull the surfaceREMOVING AND REPLACING WIREWORK
finish.SIDE RUNNERS
Remove all shelves and furniture from the oven.
Always ensure the telescopic runners are pushed
back into place in the oven cavity. Hold the bottom of
the wirework runners and draw the runners towards
the centre of the oven. Unhook from the top and
remove.
BRACKET
DO NOT ATTEMPT TO REMOVE ANY OF THE
CONTROL KNOBS FROM THE APPLIANCE AS
THIS MAY CAUSE DAMAGE AND IS A SAFETY
HAZARD.
CAVITY CENTRE
The wirework telescopic runners should not be
placed in a dishwasher. Dry carefully after washing
in hot water to which washing up liquid has been
added. If heavily soiled mild abrasives may be used.
To replace the runners, hook the wirework side
runner into the cavity, slide back and press into
Under no circumstances should the doorplace. Ensure the wirework runners are firmly in
assembly be detached from the product for
cleaning. Please refer to the cleaningposition before replacing the oven shelves.
instructions.
29 |
ACEC
