Refer to Fig. 5 for required dimensions of the Fig. 5
recess.
600
600
820�870
550
D100
The appliance is equipped with adjustable
Fig. 6
support feet (Fig. 6).
To adapt the appliance to the height of the
installation area, remove the feet, screw on nuts
(A) (which you will Ţnd in the pack) then reŢt the
feet.
Finally, adjust the height and fully tighten the A
nuts.
D101
Slide the appliance into the recess, pushing it Fig. 7
against the adjacent cabinet wall on the handle E
side.
Fasten the appliance to the worktop or the sides,
using the holes (E).
Then apply the seal-
ing strip between the refrigerator and the
adjacent cabinet (Fig. 7).
D106
The plinth (F) may be set at different depths to a Fig. 8
maximum of 55 mm (Fig. 8).
Ventilation occurs through the front ventilation
G
grille (G).
For safety reasons, minimum ventilation must be
as shown in Fig. 8.
min.
Attention: keep ventilation openings clear of 50 cm
2
obstruction.
Air enters through the right side and exits F
through the left side.
max. 55 mm
Fasten the ventilation grille into position with the
D617
two screws.
Fig. 9
Position the runners (H) at the top and bottom of
the inside of the kitchen unit as shown in Fig. 9
H
and mark the position of the external holes.
After preparing the holes, screw the runners to
the kitchen unit door using 3.5x16 mm screws.
20mm
D094
5 |
ACEC
