INSTALLATION
lf this appliance featuring magnetic door seals isThis appliance complies with the following
to replace an older appliance having a springE.E.C. Directives:
lock (latch) on the door or lid, be sure to make- 73/23 EECof 19.2.73 (Low Voltage Directive) and
that spring lock unusable before you discard thesubsequent modifications;
old appliance. This will prevent it from becoming- 89/336 EECof 3.5.89 (Electromagnetic
a death-trap for a child.Compatibility Directive) and subsequent
modifications.
Positioning
The appliance should be installed well away from
sources of heat such as radiators, boilers, direct
sunlight etc.
Best performance is obtained with ambient
temperature between +18!C and +43!C (class T);
+18!C and +38!C (class ST); +16!C and +32!C
(class N); +10!C and +32!C (class SN). The class of
your appliance is shown on its rating plate.
For safety reasons, minimum ventilation must be as100 mm
shown in Fig.:
AB
Appliance positioned under overhanging kitchen wall
units (see Fig.-A).
Appliance positioned without overhanging kitchen
units (see Fig.-B).10 mm10 mm
Attention: keep ventilation openings clear ofNP008
obstruction.
Two adjustable feet at the cabinet base allow
accurate levelling of the appliance.Door reversibility
Before carrying out the operations described below,
Electrical connectionpull out the mains plug from the wall socket.
Before plugging in, ensure that the voltage andProceed as follows:
frequency shown on the serial number plate
correspond to your domestic power supply. Voltage
can vary by +6% of the rated voltage. For operation
with different voltages, a suitably sized auto-
transformer must be used.
The appliance must be earthed.
The power supply cable plug is provided with a
contact for this purpose.
If the domestic power supply socket is not
earthed, connect the appliance to a separate
earth in compliance with current regulations,
consulting a specialist technician.
1.Remove bottom hinge (5).
The Manufacturer declines all responsibility if the2.Remove door (4).
above safety precautions are not observed.3.Unscrew pin (2) from the top hinge (1) and reŢt it
This appliance complies with EEC directiveon the opposite side.
number 87/ 308 of 2/6/87 relative to radio
interference suppression.4.Unscrew part (6) and reŢt it on the opposite side.
5.ReŢt the door and the bottom hinge on the
opposite side.
6.Remove handle (3) and reŢt it on the opposite side.
The holes that are not used are to be masked with
the plastic plugs removed.
14 |
ACEC
