Maintenance and Cleaning
Before any maintenance or cleaning work is carriedWhen the appliance is not in use
out, DISCONNECT the appliance from the
ELECTRICITY supply.When the appliance is not in use for long periods,
disconnect from the electricity supply, empty all
Internal cleaningfoods and clean the appliance, leaving the door ajar
to prevent unpleasant smells.
Clean the inside and accessories with warm water
and bicarbonate of soda (5ml to 0.5 litre of water).
Rinse and dry thoroughly.
NEVER USE DETERGENTS, ABRASIVE
POWDERS, HIGHLY PERFUMED CLEANING
PRODUCTS OR WAX POLISHES, TO CLEAN THE
INTERIOR AS THESE WILL DAMAGE THE
SURFACE AND LEAVE A STRONG SMELL.
Clean the drain hole of the water trough at regular
intervals and make sure that the drain hole is never
obstructed, so that the defrost water may flow freely.
External cleaning
Wash the outer cabinet with warm soapy water. Do
NOT use abrasive products.
Once or twice a year dust the condenser (black grill)CONDENSER
and the compressor at the back of the appliance, with
a brush or vacuum cleaner, see the figure.
You MUST ensure that the appliance is switched OFF.
An accumulation of dust will affect the performance ofCOMPRESSOR
the appliance and cause excessive electricity
consumption.D358
Changing the light bulb
Should the interior light fail to work, first switch off the
appliance and disconnect from the electricity supply,
then replace the bulb as follows, see figure.
Unscrew the light cover and then pull it outward
toward the middle of the cabinet. Unscrew the bulb
and replace it with a new 15 watt bulb (available from
your nearest Electrolux Service Centre).
Replace the light cover by sliding it into its original
position and replacing the screw.
D731
8 |
ACEC
