During a normal night time period of approximately 8 hours a traditional fridge freezer can normally maintain the
frozen food temperature but if the appliance is left for longer period in a low ambient temperature the freezer willMAINTENANCE AND CLEANING
defrost .
Before any maintenance or cleaning work is carried
Changing the light bulb
If, after the above checks, there is still a fault, call your local Service Force Centre.
out, DISCONNECT the appliance from the
In-guarantee customers should ensure that the above checks have been made as the engineer will make aELECTRICITY supply.Should the interior light fail to work, first switch off
charge if the fault is not a mechanical or electrical breakdown.the appliance and disconnect from the electricity
supply, then replace the bulb as follows;
Please note that proof of purchase is required for any in-guarantee service call
Internal cleaning
Clean the inside and accessories with warm water
and bicarbonate of soda (5ml to 0.5 litre of water).
SERVICE AND SPARE PARTS
Rinse and dry thoroughly.
NEVER USE DETERGENTS, ABRASIVE
In the event of your appliance requiring service, or if you wish to purchase spare parts, please contact your
POWDERS, HIGHLY PERFUMED
local Electrolux Service Force Centre by telephoning:-
CLEANING PRODUCTS OR WAX
POLISHES, TO CLEAN THE INTERIOR AS
THESE WILL DAMAGE THE SURFACE AND
0870 5 929929LEAVE A STRONG SMELL.
D411
External cleaning
Your telephone call will be automatically routed to the Service Force Centre covering your post code area. The
Unscrew the light cover and then pull it outward by
addresses are listed on the following pages.
Wash the outer cabinet with warm soapy water. Do
pressing as shown in the figure. Unscrew the bulb
Before calling out an engineer, please ensure you have read the details under the heading �Something NotNOT use abrasive products.
and replace it with a new 15 watt bulb (available
Working.O
An accumulation of dust will affect the performancefrom your nearest Service Force Centre).
When you contact the Service Force Centre you will need to give the following details:of the appliance and cause excessive electricity
Replace the light cover by sliding it into its original
consumption.
1.Your name, address and post codeposition and replacing the screw.
You MUST ensure that the appliance is switched
2.Your telephone number
OFFDefrosting
3.Clear and concise details of the fault
Once or twice a year dust the condenser (black grill)
4.The model and serial number of the appliance (found on the rating plate)Refrigerator
and the compressor at the back of the appliance,
5.The purchase datewith a brush or vacuum cleaner, see figure.The refrigerator automatically defrosts every time the
compressor stops. The water is discharged, via the
pipe, into a tray located at the back of the appliance
above the compressor, where it evaporates.
CUSTOMER CARE DEPARTMENT
CONDENSER
For general enquiries concerning your Electrolux appliance or for further information on Electrolux products,
please contact our Customer Care Department by letter or telephone as follows:-DEFROST
TRAY
Customer Care Department
Electrolux
COMPRESSOR
55-77 High StreetD273
Slough
Berkshire
When the appliance is not in useD037
SL1 1DZ
When the appliance is not in use for long periods,
Tel: 08705 950 950 *
disconnect from the electricity supply, empty allImportant
foods and clean the appliance, leaving the doors ajar
To avoid defrost water overflowing into the fridge,
* calls to this number may be recorded for training purposes.to prevent unpleasant smells.
periodically clean the water discharge hole in the centre
of the V shaped drip collector at the back of the
refrigerator compartment behind the fruit and vegetable
drawer. Use the defrost cleaner provided which you will
find already inserted into the discharge hole.
Remember to wash the defrost cleaner in hot soapy
water at regular intervals. Dry throughly before
replacing.
129 |
ACEC
