the appliance is empty.
USE
To carry out complete defrosting of the freezer
compartment proceed as follows:
Cleaning the interior
1. Press button ON/OFF (I) ;
Before using the appliance for the first time, wash
2. leave the door open, insert the plastic scraper inDo not use detergents or abrasive
the interior and all internal accessories with luke-
the appropriate seating at the bottom centre,powders, as these will damage the finish.
warm water and some neutral soap so as to remove
placing a basin underneath to collect the defrost
the typical smell of a brand-new product, then dry
water;
thoroughly.
3. when defrosting is completed, dry the interior
thoroughly and refit the plug; keep the scraper for
D068
future use;
Use of the fridge
4. Press button ON/OFF (I). After letting the
appliance run for at least half an hour, replace
the previously removed food into the
Control Panel
compartment.than those recommended by the manufacturer.
A temperature rise of the frozen food packs,
Important:during defrosting, may shorten their safe storage
life.
Never use sharp metal tools to scrape off frost
from the evaporator as you could damage it.
Do not use a maechanical device or any artificial
means to speed up the thawing process other
A B CDE F G
AOn/OFF light
BFridge button ON/OFF
Attention!
CUSTOMER SERVICE AND SPARE PARTS
CTemperature setting button (warmest)
During the stability period by the first starting the
DTemperature indicatortemperature displayed can not correspond to the
Y If your appliance is still not working properly after
If the appliance is not functioning properly, check
ETemperature setting button (coldest)setting temperature. During this time it is possible
that:making the above checks, contact the nearest
that the temperature displayed is lower than the
service centre.FSuper cooling light
Y the plug is firmly in the wall socket and the mainssetting temperature.
To obtain fast service, it is essential that when youGSuper cooling button
power switch is on;
apply for it you specify the model and serial numberD. Temperature indicator
Y there is an electricity supply (find out by plugging
of your appliance which can be found on the
A. Light ON/OFF
in another appliance);During normal functioning the indicator shows the
guarantee certificate or on the rating plate located
temperature inside the fridge.
Y If there are water drops on the bottom of theinside the appliance, on the bottom left-hand side.
B. Button ON/OFF
cabinet, check that the defrost water drain
opening is not obstructed (see ODefrosting�ON: Press the button (B). The pilot light (A)
Attention!
section).switches on.
Difference between the temperature displayed and
OFF: Keep press the button (B) until the pilot light
temperature setting is normal. Especially when:
(A) and the temperautre indicator switched off.
- a new setting has recently been selected
TECHNICAL INFORMATIONC - E. Temperature setting buttons- the door has been left open for a long time
- warm food has been placed in the compartment
The temperature can be adjusted between +2!C and
+8!C.F. Super cooling pilot light
Fridge Net Capacity lt.205
By pressing the button (C or E), the current
G. Super cooling button
Freezer Net Capacity lt.70temperature setting flashes on the indicator. It is
possible to modify the setting temperature only with
The maximum performance is obtained by setting
Energy Consumption kWh/24h0,86
flashed indicator. To set a warmer temperature,
the supercooling function. ItOs recommended when
press button (C). To set a colder temperature, press
Energy Consumption kWh/annuo314loading large quantities of food.
button (E). The indicator display the newly selected
Freezing Capacity kg/24h13temperature for a few seconds and then showsPress the supercooling button (G).The relevant pilot
again the inside compartment temperature.light (F) switches on.
Rising Time20
The internal temperature goes down to +2!C.
The newly selected-temperature must be reached
after 24 hours.
The Technical info are on the rating plate situated on the left inside the appliance.After about 6 hours the supercooling function
switches off automatically.
3831 |
ACEC
