132990370.qxd 29/03/2004 09:52 Pagina 10 (Nero/Process Black pellicola)
Important! An alarm code indicates a fault in the machine
The first time you use the washing machine,operation (see the relevant chapter on page 22).
when you switch it on, it may display a blinking zero.
This is due to the fact that the washing machine has
performed a washing cycle during the manufacturers
inspection tests, and this cycle has not been erased
after its completion.
Delay start, a time value indicated in hours and
selected by means of the relevant button.
9 START/PAUSE button
This button has two functions:
Start: after you have selected the desired
programme and options, press this button to start
the washing machine. The light above the button
will stop flashing and remain lit.
The delay time is displayed for 3 seconds, then theIf you have selected a delay time by means of the
duration of the selected programme reappears.relevant button, the countdown will begin and will
After you have pressed the START/PAUSE button,be shown on the display.
the countdown begins, and the delay time value Pause: when you press this button again, the
decreases by one unit every hour till the first 2programme in progress is interrupted. The light
hours, and then it decreases by one unit every 30above the button will start flashing. To restart the
minutes.programme, press the button again.
You can delay the start of every programmeImportant! You must set the washing machine to
selecting the DELAY START button. The delay timePAUSE before you make any change in the
is indicated first by 30-60-90 minutes, and then byprogramme in progress.
hours up to 23 hours.
An incorrect option selection has been made:
this is indicated by the message Err when a10 SKIP RESET button
function incompatible with the current programmeAt the end of a programme, you must press this
is selected.
button once or repeatedly, in order to clear the
contents of the memory (the display will show three
blinking dashes); otherwise, the next time you switch
the washing machine on, the blinking zero will
reappear.
You can also press the SKIP RESET button to
exclude one or several phases of the programme
which is running, as indicated below.
- set the washing machine to PAUSE by pressing the
START/PAUSE button (the relevant light will flash);
- press the SKIP RESET button once or several
times, until the required phase(s) is(are) cancelled
10 |
ACEC
