132978230 GB.qxd 10/10/2006 8.48 Pagina 57 (Nero/Process Black pellicola)
? Place a bowl on the floor to collect any spillage. ? clean the pump if necessary as previously
? Pull out the emergency emptying hose, place it indescribed;
the bowl and remove its cap.? replace the emergency emptying hose in its seat
? When no more water comes out, unscrew theafter having plugged it;
? screw the pump cover again and close the door.
7. Frost precautions
If the machine is installed in a place where the
temperature could drop below 0°C, proceed as
follows:
? Remove the plug from the socket.
? Close the water tap and unscrew the water inlet
hose from the tap.
pump cover and remove it.
? Remove any objects from the pump impeller by? Place the end of the emergency emptying hose
rotating it.and that of the inlet hose in a bowl placed on the
floor and let water drain out.
? Put the cap back on the emergency emptying hose? Screw the water inlet hose back on and reposition
and place the latter back in its seat.
the emergency emptying hose after having put the
cap on again.
By doing this, any water remaining in the machine is
removed, avoiding the formation of ice and,
consequently, breakage of the affected parts.ENGLISH
When you use the machine again, make sure that
the ambient temperature is above 0°C.
Important!
Every time you drain the water through the
? Screw the pump cover fully in.emergency emptying hose you must pour 2 litres of
? Close the pump door.water into the main wash compartment of the
detergent drawer and then run the drain programme.
This will activate the ECO valve avoiding that part of
6. Emergency emptying outthe detergent remains unused at next washing.
If the water is not discharged, proceed as follows to
empty out the machine:
? pull out the plug from the power socket;
? close the water tap;
? if necessary, wait until the water has cooled down;
? open the pump door;
? place a bowl on the floor and place the end of the
emergency emptying hose into the bowl. Remove
its cap. The water should drain by gravity into the
bowl. Whe the bowl is full, put the cap back on the
hose. Empty the bowl. Repeat the procedure until
water stops flowing out;
57 |
ACEC
