Safety Precautions
If not used properly this trimmer can be dangerous! This trimmer can cause serious injury to
the operator and others, the warnings and safety instructions must be followed to ensure
reasonable safety and efficiency in using this trimmer. The operator is responsible for following
the warning and safety instructions in this manual and on the trimmer.
Explanation of Symbols on the Contour Power Plus7. Do not pull cable around sharp objects.
8. Always switch off at the mains before disconnecting
any plug, cable connector or extension cable.
Warning9. Never pull on the cable to disconnect any of the plugs.
10. Switch off, remove plug from mains and examine
electric supply cable for damage or ageing before
winding cable for storage. Do not repair a damaged
Read the user instructions carefully tocable, replace it with a new one. Use only Flymo
make sure you understand all thereplacement cable.
controls and what they do.11. Always wind cable carefully, avoiding kinking.
12. Use only on AC mains supply voltage shown on the
Keep others, including children, petsproduct rating label.
10m360o13. Flymo trimmers are double insulated to EN60335.
and bystanders outside the 10 metre
hazard zone. Stop the trimmerUnder no circumstance should an earth be
connected to any part of the trimmer.
immediately if you are approached.
Cables
Use only 1.00mm2 size cable up to 40 metres length
The use of eye protection ismaximum.
recommended to protect againstMaximum rating:
objects thrown by the cutting line.1.00mm2 size cable 10 amps 250 volts AC
1. Mains cables and extensions are available from your
local Electrolux Outdoor Products Approved Service
To avoid the possibility of electricCentre.
shock, do not use in damp or wet
2. Only use extension cables specifically designed for
conditions.outdoor use.
Preparation
1. While using your product always wear substantial
Switch off! Remove plug from mains
footwear and long trousers.
before adjusting, cleaning or if cable is2. Before using the machine and after any impact,
entangled or damaged.
check for signs of wear or damage and repair as
Warning: The cutting line continues to rotate after thenecessary.
machine has been switched off.3. Inspect the area to be cut before each use. Remove
Generalall objects such as stones, broken glass, nails, wire,
1. Never allow children or people unfamiliar with thesestring etc, which can be thrown or become
entangled in the trimmer head.
instructions to use the trimmer. Local regulations
may restrict the age of the operator.4. Check that the cutting head is fitted correctly.
Use
2. Only use the trimmer in the manner and for the
functions described in these instructions.AVOID ACCIDENTAL STARTING. REMOVE PLUG
3. Never operate the trimmer when you are tired, ill orFROM MAINS AND KEEP FEET AWAY FROM THE
under the influence of alcohol, drugs or medicine.SWITCH LEVER WHEN:- CLEANING AROUND THE
4. The operator or user is responsible for accidents orINSIDE OF THE SAFETY GUARD, REMOVING OR
hazards occurring to other people or their property.REFITTING SPOOL CAP, MANUALLY FEEDING OR
ElectricalREPLACING NYLON LINE.
1. The use of a Residual Current Device (R.C.D.) with1. Use the trimmer only in daylight or good artificial
a tripping current of not more than 30mA islight.
recommended. Even with a R.C.D. installed 100%2. Avoid operating your trimmer in wet grass, where
safety cannot be guaranteed and safe workingfeasible.
practice must be followed at all times. Check your3. Take care in wet grass, you may lose your footing.
R.C.D. every time you use it.4. On slopes, be extra careful of your footing and wear
2. Before use, examine cable for damage. If there arenon-slip footwear.
signs of damage or ageing, it must be replaced by5. Do not walk backwards when trimming, you could
the manufacturers service agent or a similartrip. Walk never run.
qualified person to avoid hazard.6. Keep cutting head below waist level.
3. Do not use the trimmer if the electric cables are7. Switch off before pushing the trimmer over surfaces
damaged or worn. other than grass.
4. Immediately disconnect from the mains electricity supply8. Never operate the trimmer with damaged guards or
if the cable is cut, or the insulation is damaged. Do notwithout guards in place.
touch the electric cable until the electrical supply has9. Never fit metal cutting elements.
been disconnected. Do not repair a cut or damaged10. Keep hands and feet away from the cutting means
cable. Replace it with a new one. at all times and especially when switching on the
5. Your extension cable must be uncoiled, coiled cablesmotor.
can overheat and reduce the efficiency of your trimmer.11. Never pick up or carry a trimmer by the cable.
6. Keep the cable clear of the cutting area and12. Do not lean over the trimmer guard - objects may be
obstacles at all times.thrown by the cutting line.
ENGLISH - 1 |
ACEC
