Guided Tour - Model 2000 Rear Panel
1356
EFFECT
Hartke Systems
Distributed Exclusively by115
Samson Technologies Corp.
Hicksville, New York 11802
MODEL 2000~ AC INPUTRETUIRNSEND
200 WATTS115V/230V 50/60Hz
8& = 120 WATTSFUSE5A/250V, 180W (115V)SPEAKER OUTPUTS
4& = 200 WATTS2.5A/250V, 450W (230V)
CAUTION
TO PREVENT SHOCK, DO NOT OPEN. NO USER SERVICE-
ABLE PARTS INSIDE. REFER SERVICING TO QUALIFIED SERVICE PERSONNEL. TO PREVENT FIRE OR SHOCK HPF
HAZARD, DO NOT EXPOSE TO RAIN OR MOISTURE.OFFON
8&8&
SERIAL NUMBER
ASSEMBLED IN R.O.K.
247
1. Fuse sled- This contains a fuse holder and shows the currently selected volt-
age rating for your Model 2000. Make sure the voltage rating is correctly set
before powering up the amplifier! Fuse ratings are 5 amp for 115 VAC and
2.5 amp for 230 VAC. For information on how to change the voltage rating, see
Appendix C on page 18.
2. AC input- Connect the supplied standard 3-pin OEEC � plug here.
3. Fan - The fan provides vital cooling to your Model 2000. Make sure that it is
kept free of all obstructions and that cool, fresh air is accessible at all times.
Also, try to ensure that the Model 2000 is used in a dust-free environment.
4. HPF Off/On switch- When on, the very lowest (subsonic) frequencies output
by your Model 2000 are filtered (removed), providing protection to connected
speakers. As a result, speaker movement (excursion) will be reduced, thus
significantly extending the life of your speakers.
We recommend that you keep the HPF Off/On switch at the OOn� position
at all times unless you are specifically using the Model 2000 with speakers
specifically designed for ultra-low frequency reproduction (i.e. sub-
woofers). Speaker damage (to Hartke transducers) will not be covered by
warranty if it is determined to have been caused by over-excursion.
7 |
ACEC
