Guided Tour - Model 2000 Rear Panel
5. Effect Return jack- Use this 1/4� unbalanced jack to return low impedance
(600 ohm) signal to the Model 2000 from a professional outboard effects
processor such as a reverb, echo, chorus, flanger, or harmonizer device.*
6. Effect Send jack - Use this 1/4� unbalanced jack to send low impedance
(600 ohm) signal from the Model 2000 to a professional outboard effects proces-
sor such as a reverb, echo, chorus, flanger, or harmonizer device.* Output level
is approximately 0 dB to +4 dB and is post-EQ and post-compression but
unaffected by the setting of the Master Volume control. You can also use the
Effect Send jack to route signal to an external mixing console or amplifier with
an input sensitivity of +4 dB.
7. Speaker outputs- Connect any 4, 8, or 16 ohm bass cabinet(s) to these
standard unbalanced 1/4� jacks. WARNING: Because of the high power
levels and low frequency content of the signal generated by the Model
2000, use only appropriately rated speaker cabinets (at least 250 watts at 4
ohms) that are specifically designed for bass instruments. We recommend
that Hartke amplifiers be used with Hartke bass cabinets, although other brands
of speakers can be used.
* In-line effects (such as footpedals) intended for low signal levels should be
placed between the bass and the amplifier Input and not connected with the
Effect Send and Return jacks.
8 |