2.6 Raster position adjustment= PROGRESSIVE
MODE
Adjustment preparation
53SWX01W 565
(1) The set can face east or west.
61SWX01W 650
(2) Input the single cross test signal.
(3) Set video conditions to factory preset.Tolerance: ? 5mm
(4) The electric focus should have been coarse
adjusted.
(5) The digital convergence RAM should be cleared
(uncorrected state). With the TV set off, press
and hold the service switch located on the
Power/Deflection PWB and then press the
Notes: (1) If internal cross-hatch does not
power button.
appear after clearing RAM data,
(6) Start adjustment after TV is turned on for 20
press service switch again (on
minutes or more.
POWER/DEFLECTION PWB).
(2) To restore old RAM data, turn TV
Adjustment procedure
off and on.
(1) Turn the centering magnets for red, green, and
2.8 Horizontal size adjustment
blue to satisfy the condition below. The red and
blue horizontal lines should match with green.
Adjustment preparation
1(RED) (BLUE)2(1) The set can face east or west.
(2) Set video conditions to factory preset.
53SWX01W2030
(3) The electric focus should have been coarse
61SWX01W2030adjusted.
(4) Start adjustment after TV is turned on for 20
Tolerance: ? 2mm
RBminutes or more.
Adjustment procedure
PROGRESSIVE MODE
(1) Receive any NTSC signal.
(2) Press the SERVICE ONLYSW on
Geometric
DEFLECTION PWB.
center of the
(3) Locate the horizontal size VR (R683) (see page
screen
53). Adjust horizontal size to the table below.
HD MODE
12
(1) Input 1080i (fH=33.75kHz) component signal to
(2) Upon completion of adjustment, fix centeringVIDEO 1 or 2.
magnets with white paint.
(2) Press the SERVICE ONLYSW on
DEFLECTION PWB.
NOTES: (1) If internal cross-hatch does not appear
(3) Locate the horizontal size VR (R686) (see page
after clearing RAM data, press service
53). Adjust the horizontal size to the following
switch again.
table.
(2) To restore old RAM data, turn TV off and
on.=PROGRESSIVEHD
MODEMODE
2.7 Vertical size adjustment
53SWX01W 1150 1150
Adjustment preparation61SWX01W13201320
(1) The set can face east or west.Tolerance: ? 5mm
(2) Set video conditions to factory preset.
(3) The electric focus should have been coarse
adjusted.
(4) Start adjustment after TV is turned on for 20
minutes or more.
Adjustment procedure
PROGRESSIVE MODE
(1) Receive any NTSC signal.
(2) Press the SERVICE ONLYSW onNotes: (1) Once Prog. mode Horizontal size adj. is
DEFLECTION PWB.done, do not touch the VR (R683) again.
(3) Locate the vertical size VR (R630) (see pageMove to HD Horizontal Size Adjustment.
53). Adjust the vertical size according to the (2) To restore old RAM data, turn TV off and on.
following table.
41 |
ACEC
