ASSEMBLY
Fitting the bar and chainTension the chain by turning the chain tensioning screw
clockwise using the combination spanner. The chain should
be tensioned until it does not sag from the underside of the
bar. See instructions under the heading Tensioning the chain.
WARNING! Always wear gloves, when
!working with the chain.
340, 340e, 350
Check that the chain brake is in disengaged position by
moving the front hand guard towards the front handle.
The chain is correctly tensioned when it does not sag from the
underside of the bar, but can still be turned easily by hand.
Hold up the bar tip and tighten the bar nuts with the
combination spanner.
Remove the bar nuts and remove the clutch cover (chain
brake). Take off the transportation ring (A).
When Ţtting a new chain, the chain tension has to be checked
frequently until the chain is run-in. Check the chain tension
regularly. A correctly tensioned chain ensures good cutting
performance and long life.
Fit the bar over the bar bolts. Place the bar in its rearmost
position. Place the chain over the drive sprocket locate it in 345e
the groove on the bar. Begin on the top edge of the bar.
Check that the chain brake is in disengaged position by
moving the front hand guard towards the front handle.
Make sure that the edges of the cutting links are facing
forward on the top edge of the bar.
Fit the clutch cover and locate the chain adjuster pin in the Remove the knop and remove the clutch cover (chain brake).
hole in the bar. Check that the drive links of the chain Ţt Take off the transportation ring.
correctly over the drive sprocket and that the chain is correctly
located in the groove in the bar. Tighten the bar nuts Ţnger
tight.
English � 17 |
ACEC
