Connecting antennas
To use the tuner of the DTR-6.4/5.4, it is necessary to prepare the
supplied FM and AM antennas.Connecting the included antennas
Y Adjustment and placement of the FM and AM antennas for
Connecting the FM indoor antenna:
better reception must be done while listening to a station
The FM indoor antenna is for indoor use only. During use, extend
broadcast.
the antenna and adjust its orientation until the clearest signal is
Y If better reception cannot be obtained, then placement of an
received. Fix it with push pins or similar items in the position that
outside antenna is recommended.
will cause the least amount of distortion.
If the reception is not very clear with the attached FM indoor
antenna, the use of an outdoor antenna is recommended.
Assembling the AM loop antenna
Connecting the AM loop antenna:
The AM loop antenna is for indoor use only. Set it in the direction
Assemble the loop antenna as shown in the illustration.
and position where you receive the clearest sound. Put it as far away
Y Refer to OConnecting the AM loop antenna� below for details
as possible from the DTR-6.4/5.4, televisions, speaker cables, and
on how to connect the loop antenna.
power cords.
If the reception is not very clear with the attached AM indoor
antenna, the use of an outdoor antenna is recommended.
FM antenna
(Indoor)
AM loop antenna
Australian models
Insert into the hole
Connecting the AM antenna cable
1. Press down the lever at the antenna terminal.
2. Insert the wire into the terminal hole.ANTENNAAMFM75
3. Release the lever.
TRIGGER12 VZONE 2
OUT56KIR OUT40K ZONE 2DC INLINE OUT
OUT24V 1A
AAL
123B
USA and
Canadian
models
Hint:
Either of the split ends of the AM antenna can be connected to
either terminal. Unlike speaker cabling, there is no polarity for AM
broadcast signals.
24 |
ACEC
