Programming Buttons
You can program the remote controller commands by transmittingProgramming control panel buttons
infrared signals from your existing remote controls to the remote
controllerOs learning eye. To do this, place the remote controller and1. Navigate to the control panel buttons you want to
the deviceOs remote controller on a flat surface, 6 to 8 inches(15 to 20program.
cm ) apart.
2. Switch to LEARN mode by using the Mode button.
The following buttons can be programmed: control panel buttons,Additional empty buttons appear: they can be programmed and
Device menu items, direct-access buttons and Left/Right buttons.labeled as existing buttons.
3. Point the deviceOs original remote controller to the
remote controllerOs learning eye as shown on this
page.
4. Tap the remote controller button you want to
program.
The button starts blinking.
5. Press and hold the corresponding button on your
6 to 8 inchesdeviceOs original remote controller.
(15 to 20 cm )If the remote controller has learned the command successfully,
OK blinks on the remote controller icon. You can let go of the
button youOre holding.
If the remote controller has not learned the command
successfully, you hear a short buzz and FAIL appears on the
remote controller icon.
6. Program all other buttons you want and relabel them
as necessary (see page 72).
7. Return to Use mode by using the Mode button.
You cannot program Home menu buttons directly. You need to
program them by following the Device menu.
The remote controller also offers empty control panel buttons you
can program and labelL as existing buttons. They are only visible in
LEARN and LABEL mode and appear without label or with label
(intended for a specific function). You will also see previously
deleted buttons: you can restore them by reprogramming them or
you can reuse them for other commands.
70 |
ACEC
