Filename [DR-MH30EU_09Editing.fm]
DR-MH30EU_00.book Page 63 Monday, June 14, 2004 8:03 AMMasterpage:Right0
REMOTE CONTROL
EN 63
CABLE/SAT
Remote Control Functions
TV AV/VIDEOTVDVD
1
Remote Control 1/2/3/4 Code Switching
The remote control is capable of controlling four JVC video units TV% +/-
independently. Each of the units can respond to one of four codes 0 - 9
(1, 2, 3 or 4). The remote control is preset to send 3 code signals
PR +/-
because your unit is initially set to respond to 3 code signals. You
can easily modify your unit to respond to 1, 2 or 4 code signals.
TV
Slide the TV/CABLE/SAT/DVD switch to DVD.ENTER
4
1
SET UP
CABLE/SAT
TVDVD
TV Multi-Brand Remote Control
1 - 4
Your remote control can operate the basic functions of your TV set.
In addition to JVC TVs, other manufacturer?s TVs can also be
controlled.
I Turn off the TV using its remote control.
ENTERI Slide the TV/CABLE/SAT/DVD switch to TV.
IMPORTANT:
Although the provided remote control unit is compatible with JVC
televisions, as well as many other models, it may not work with your TV,
or in some instances, may have limited function capability.
8I Keep pressing SET UP down during step 1.
1Enter your TV?s brand code using the number keys, then press
ENTER.
2Press 1 on the unit?s remote control to turn on the TV and try
SET UP
operations ( step 3).
I Once you have set the remote control to operate the TV, you do not
have to repeat this step until you replace your remote control?s
batteries.
I Keep pressing SET UP down during step 1.I Some brands of TVs have more than one code. If the TV does not
1Press the number key ?1? for 1, ?2? for 2, ?3? for 3 or ?4? for 4 function with one code, try entering another.
to change the remote control code, then press ENTER.3Press the corresponding buttons to operate the TV: 1, TV AV/
2Press 1 on the unit to turn off the unit.VIDEO, PR +/-, TV% +/-, TV , number keys.
I For some brands of TVs, you must press ENTER after having
3Press 4 on the unit for over 5 seconds while the unit is turned pressed the number keys.
off. The code currently set appears on the front display panel.
4Press 8 on the remote control to change the unit?s code. The BRAND NAMECODE
code currently set on the remote control blinks on the front display
JVC01, 03
panel for approximately 5 seconds, and is applied to the unit.
HITACHI10
NOTE:MAGNAVOX02
When ?POWER SAVE? is set to ?ON? ( pg. 69), it is not possible to MITSUBISHI03
change the remote code.PANASONIC04, 11
RCA05
SHARP06
SONY07
SAMSUNG12
SANYO13
SEARS13
TOSHIBA08
ZENITH09
Page 63Friday, 11 June 2004 21:53 |
ACEC
