MasterPage: Body_Left
GZ-MC200PAL.book Page 22 Wednesday, September 8, 2004 2:13 PM
22 ENBASIC OPERATIONS
NOTES:Still Image Recording
I If shooting is not performed for approx. 5 minutes when
using the battery pack, the camera?s power shuts off
automatically. To perform shooting again, set the power MODE
switch to OFF, then to . When using AC adapter, the
Power Switchcamera enters the power save mode. To cancel the power
save mode, perform any operation such as zooming.
I To turn the shutter sound off, see page 26.
I For approximate number of storable images, see page 42.
Recording Start/Stop Button
Continuous Shooting
Keeping the recording start/stop button pressed in step 3
Lock Button
provides an effect similar to serial photography. (Interval
between still images: approx. 0.3 seconds)
To use this function, set [CONTINUOUS SHOOTING] to
1Set the power switch to while pressing down the [ON]. ( pg. 26, 29)
lock button located on the switch.I Continuous shooting may not work well depending on
2Press MODE to select .the recording medium.
I The camera is programmed to record still images on the
medium in the SD slot by the factory preset. To switch the Deleting Files
recording medium, see pages 26 and 27.
If you press during recording mode, the file recorded
I To change the image size and picture quality, see pages 26
most recently will be deleted.
and 29.
I However, if the recording mode (video, still image or voice) is
3Press the recording start/stop button. The still image is switched or the power is turned off and on again after
recorded.recording, you cannot delete the file.
I To check how the image looks before recording, press the
recording start/stop button halfway and hold. The
indicator appears and stops blinking when the captured
image is focused. To cancel the recording, release the
recording start/stop button. To record it on the recording
medium, press the recording start/stop button fully. |
ACEC
