By adjusting the main parameters, you can tweak your sound to whator [1 ] buttons to cycle the displaLEy through (program level), nr (NR
you have in mind.sensitivity), and Cb (cabinet). Use the value knob to adjust each param-
eter.
Selecting and adjusting sub-parametersLE:Use the value knob to adjust the program level (0.0�10). A setting
of 5.0 is the standard value. Some effect settings may cause clip-
[PRE FX-PARAM], [DRIVE/AMP-PARAM], [MOD-PARAM],ping. If this occurs, lower the program level.
[DELAY/REV-PARAM]
nr:Adjust the noise reduction sensitivity (0.0�10) so that you donOt hear
HereOs how to edit the sub-parameters of the effect youOve selected fnoise (hiss) when yorouOre not playing your guitar.
each of the [PRE FX], [DRIVE/AMP], [MOD], and [DELAY/REV] catego-
Depending on the guitar youOre using, notes may be cut off if you
ries.
raise the noise reduction value excessively. Adjust this so notes ring
When you press the [2 ] or [1 ] buttons, the program/value display will
out naturally.
indicate a value of P1�P5, and the LED at the top of the Program Down
switch will light to indicate that the program/value displaCb:Select the type (C0�C9) of cabinet modeling.y is showing the
parameter type.You canOt edit the cabinet model if the drive/amp model is off. In this
case, the LED will indicate �. O
For the sub-parameters that correspond to P1�P5, refer to p.43 OAppen-
dices�.Cabinet modeling is associated with the drive/amp model. It works
Now you can use the value knob to adjust each sub-parameter to yonly if the drourive/amp model is turned on. When you change the drive/
taste.amp model type, the most suitable cabinet model is selected auto-
matically.
At this time, the program/value display indicates the value of the param-
eter, and the LED at the top of the Program Up switch will light to indi-Cabinet modeling is associated with the drive/amp model. It works
cate that the program/value display is showing the parameter vonly if the dralue.ive/amp model is turned on. When you change the drive/
amp model type, the most suitable model is selected automatically.
If the effect is turned off, the program/value displa � y will indicate O
when you set the function selector to a [PARAM] position fEffecor that cat-t/parameter type and parameter value display
egory. If you want to edit the parameters of that effect, simultaneously
When you press the Program Down switch in Edit mode, the program/
press both [2 ] and [1 ] buttons to turn the effect on.
value display will indicate the effect type or parameter type (F0�F9, d0�
 Quick guided7, A0�A7, P1�P5). When you press the Program Up switch, the pro-
To select an effect and edit it to your taste, you should first adjust the maingram/value display will indicate the parameter value. This gives you a
parameters, and then adjust sub-parameter P1. In most casesconv, yenient wouOll beay to check the current settings.
able to get the sound you want by adjusting these two parameters.
Saving a program (Write mode)
[LEVEL/NR/CAB]
HereOs how to save (write) a sound that youOve created.
Set the function selector to this position when you want to adjust the
If you switch to a different program in Program mode or turn off the power
program level, noise reduction, or cabinet modeling.2 ]Then press the [
without writing your settings into memory, the changes you made will be lost.
8 |
ACEC
