$$/@@FOH1.�?´
TROUBLE SHOOTING
If you think a malfunction has occurred, first check The disc stops in mid-operation. A specific CD cannot be played.
the points listed below. The problem is likely toThe sound drops out or noise isCopy control CDs (CDs with copy guard) are
have been caused by a simple operational error. If
special discs that do not comply with current
the problem cannot be corrected even afterheard.
CD standards. Marantz cannot guarantee theENGLISHcarrying out the following checks, consult your1. Is the disc dirty?
dealer or nearest Marantz sales office or serviceability to play such discs on your CD player.
counter.2. Is the disc scratched?When normal CDs can be played without a
3. Is the disc warped?problem and problems occur only when playing
The disc fails to rotate.* In the case of a CD-R or CD-RW disc, thisthese special discs, it is not a problem with this
1. Is the AC Power cord plugged in properly?problem may occur when the conditions underunit.
which its data was originally written werePlease ask the seller of the copy control CD for
2. Is the POWER ON/STANDBY switch ON?substandard or when the quality of the disc
detailed information regarding copy control
3. Is the disc placed in the correct position? itself is poor.CDs.
4. Is the disc placed properly with the label side* This condition may occur in Mixed-Mode CDs,
CD Extra, and other discs that have CDDA
facing up? MP3 music data cannot be played.
format mixed with other data.
5. Is the disc dirty? Noise may also be heard momentarily whenThere are some restrictions on the MP3 music
6. Is the disc scratched? skipping tracks.data which can be played on this unit. For
details, please refer to �PLAYING MP3 FILES�
7. Is the disc warped?
Remote control operation is noton page 2.
possible.
The disc is rotating but no sound The unit makes a clicking sound
is heard.1. Is the transmitter of the remote control unitwhen the tray closes.
(RC4001CC) pointed correctly at the remote
1. Are the amplifier and speakers connected
sensor on the front of the player (this unit)?This is the adhesion click of the clamper for
properly?
(See page 4)securing the disc.
2. Is the amplifier switch ON?This does not cause any problem in using the
Are there any obstacles between?
3. Is the amplifier�s function or selector switch setunit.
2. Are the batteries in the remote control unit
to �CD� or �AUX� or such (or whatever you
exhausted?
have connected this unit to)? While the disc is spinning, a spinning
3. Is there another strong light striking thesound is heard or a slight vibration
4. Is the amplifier�s volume control set at the
player�s remote sensor?
minimum level?occurs.
4. Is EXT./INT. switch on the unit back panel set
Depending on the disc, a spinning sound may
in the correct place? (See page 7)
occur or the unit may vibrate slightly due to
disc eccentricity or such. This is not a problem
CD-R/CD-RW disc cannot be
with this unit.
played. (See page 2)
1. Is the disc placed upside down?
2. Is the disc finalized correctly (TOC written)?
3. Is the recorded information music format (CD-
DA) or MP3 music data?
19 |
ACEC
