The NAD 533 Turntable
Counterweight
PlatterTonearm
Bias
adjustment
Lift/lower
mechanism
Arm clip
On/off switch
Plinth
Mat
Spindle
Arm Wiring
Sub platter
Blue = LH earth
Green = RH earth
Red = RH signal
White = LH signal
Anti-vibration feet
Setting up the cartridge
With the cartridge fitted using the alignment protractor supplied and the wiring chart (shown left), next set the
tracking force and thrust bias. First, slide off the plastic protection shroud from the cartridge... Carefully
Unclip the arm from its holder and make sure that the bias adjuster is set to zero, use the balance weight to �floatO
the stylus about 1mm clear of a record, then dial inwards with the weight, (1 complete turn = 2g) until the cartridgeOs
tracking weight is achieved. Finally, set the bias adjuster to the same setting. |
ACEC
