Connecting Other ComponentsNContinued
Connecting an Onkyo Cassette Deck
The following diagram shows how to connect an optional Onkyo cassette deck.
Connect the CD receiverOs MD/TAPE OUT jacks to the cassette deckOs INPUT (REC) jacks, and connect the CD
receiverOs MD/TAPE IN jacks to the cassette deckOs OUTPUT (PLAY) jacks.
CD receiverOs
Onkyo cassette deckOs
rear panel
rear panel
LINE 1
RedINPUT OUTPUT
IN(REC)(PLAY)REMOTE
CONTROL
L
OUTWhite
MD/
TAPEAnalog audio cables (RCA)R
INWhite
OUT
Red
DOCK/
CDR
INWhiteRed Red White
RL
cable supplied with
the Onkyo cassette deck
What can you do with ?
Y Connecting an Onkyo cassette deck to the CD receiver with an cable allows you to control the cassette deck with
the CD receiverOs remote controller. In addition, when playback is started on the cassette deck, the CD receiver will
automatically select it as the input source.
YTo use , you must connect the Onkyo cassette deck to the CD receiver with an cable and an analog audio
cable (RCA). In addition, the Input Display for the MD/TAPE jacks must be set to OTAPE.� Since this is the default
setting, unless youOve changed it, it can be left as it is (see page 27).
Y Some -capable components have two jacks. TheyOre both the same, so you can use either one. The extra jack
is for connecting additional -capable components.
18 |