PREPARATION� Power �
Connecting to the AC adapter
Connect the provided AC adapter to the main unit.
WARNING :SHOCK HAZARD - DO NOT OPEN.
AVIS :RISQUE DE CHOC ELECTRIQUE - NE PAS OUVRIR.
Screw
DV IN/OUT
Provided AC adapter
Clamp
AUDIOVIDEOAC
I
N
9PIN REMOTEDC12V
OAUXNTSC PALProvided AC
U
Tmains cable
CH 1/3CH 2/4LINES -VIDEO
DC IN terminalDC cord
POWER indicator1.Connect the DC cord of the AC adapter
to the DC IN terminal of the main unit.
POWER
2.To prevent accidental disconnection of
A.DUBthe DC cord, fasten the DC cord with a
DVCAM NTSC PAL REC INH.clamp.
AG-DV2500
1 / 3
MICREMOTEINPUTCHOFFLINE2 / 41Remove 1 screw followed by the clamp.
AUDIO2Insert the DC cord into the clamp and fasten
9PIN WIRELESSDV S-VIDEO
the clamp unto the main unit.
POWER button
3.Connect the provided mains cable to
the AC IN terminal of the AC adapter.
Memo
4.Connect the power plug to an AC 120V,
YEven in the POWER OFF mode, a small
50 Hz/60 Hz socket.amount of electricity will still flow into the unit.
YPower is channeled into the unit and the
Y When the unit is in the POWER OFF mode,
POWER indicator lights up red.
no operation can be performed except that
(POWER OFF mode)
of the POWER buttons (on the main unit and
Y If the DC IN MODE item of the SYSTEM
the remote controller) and cassette loading/
menu is set to OPOWER ON� or OPLAY�, the
ejecting.
POWER indicator will light up green.
(POWER ON mode)
If it is set to PLAY, the VTR will automatically
start to play the loaded tape.
Notes
Y Please supply power to the unit via the provided AC adapter. Do
not use other power sources.
Y During recording or playback, please do not unplug the DC or
LOW VOLTAGEmains cable.
Y When the supply voltage is low, the OLOW VOLTAGE� alarm mes-
sage will be displayed. ( Page 62)
Alarm message
E-26
DV2500P_p24-32262/27/03, 8:00 PM |
ACEC
