Important Safeguards and Precautions
TO REDUCE THE RISK OF ELECTRIC SHOCK, FIRE, INJURY TO PERSONS OR DAMAGE TO
THIS PRODUCT, READ AND RETAIN ALL SAFETY AND OPERATING INSTRUCTIONS. HEED ALL
WARNINGS IN THE MANUAL AND ON THE PRODUCT.
INSTALLATIONOUTDOOR ANTENNA INSTALLATION
1 POWER SOURCE CAUTION1 SAFE ANTENNA AND CABLE CONNECTION
Operate only from a power source indicated on the unit or in thisIf an outside antenna or cable system is connected to the equipment, be sure the
manual. If necessary, have your Electric Utility Serviceantenna or cable system is grounded so as to provide some protection against
Company or Video Products Dealer verify the power source inbuilt up static charges and voltage surges.
your home.Section 810 of the National ELECTRICAL CODEANTENNALEAD INNEC- NATIONAL
WIRE
Electrical Code, ANSI/NFPA 70
2 POLARIZED OR GROUNDING PLUGGROUND CLAMP
As a safety feature, this product comes with either a polarized(in Canada, part 1 of the Canadian ElectricalANTENNA
Code) provides information with respect toDISCHARGE UNIT(NEC SECTION 810-20)
power cord plug (one blade is wider than the other), or a three-ELECTRICSERVICE
proper grounding of the mast and supportingEQUIPMENTGROUNDING CONDUCTORS(NEC SECTION 810-21)
wire grounding type plug.GROUND CLAMPS
structure, grounding of the lead-in wire to an
POLARIZED PLUG CAUTION:antenna discharge unit, size of grounding conductors,POWER SERVICE GROUNDINGELECTRODE SYSTEM(NEC ART 250, PART H)
This plug will only fit into an outlet one way. If you cannot fully insertlocation of antenna discharge unit, connection to grounding
the plug, try reversing it. If it still will not fit, have an electricianelectrodes and requirements for the grounding electrode.
install the proper wall outlet. Do not defeat the safety feature by2 KEEP ANTENNA CLEAR OF HIGH VOLTAGE POWER LINES OR
tampering with the plug.CIRCUITS
GROUNDING PLUG CAUTION:An outside antenna system should be located well away from power lines,
This plug will only fit into a three-hole grounding outlet. If necessary,electric light or power circuits and where it will never come into contact with
have an electrician install the proper outlet. Do not defeat the safetythese power sources if it should happen to fall. When installing an outside
feature by tampering with the plug.antenna, extreme care should be taken to avoid touching power lines, circuits or
other power sources as this could be fatal. Because of the hazards involved,
3 POWER CORD
antenna installation should be left to a professional.
Make sure power cords are routed so that they are not likely to
have anything rest on them, roll over them, or be in the way ofUSING THE UNIT
walking traffic. If an extension cord is used, make sure it also
has either a polarized or grounded plug and that the cords canIf the unit has been in storage or moved to a new location, refer first to the
be securely connected. Frayed cords, damaged plugs, andINSTALLATION section of these safeguards.
damaged or cracked wire insulation are hazardous and should1 KEEP THE UNIT AWAY FROM WATER OR MOISTURE OF ANY KIND.
be replaced by a qualified service technician.2 IF EQUIPMENT IS EXPOSED TO RAIN, MOISTURE, OR STRONG
Overloaded outlets and extension cords are fire hazards andIMPACT, unplug the unit and have it inspected by a qualified service technician
should be avoided.before use.
4 DO NOT BLOCK VENTILATION HOLES3 DURING AN ELECTRICAL STORM
Ventilation openings in the cabinet release heat generated duringDuring a lightning storm, whether indoors or outdoors, or before leaving the unit
operation. If they are blocked, heat build-up inside the unit canunused for extended periods of time, disconnect all equipment from the power
cause failures that may result in a fire hazard or heat damage tosource as well as the antenna and cable system.
cassettes or discs.4 WHEN THE UNIT IS PLUGGED IN
For protection, follow these rules: Never expose the unit to rain or water. DO NOT OPERATE if liquid has been
a. Never cover ventilation slots or the unit while in use, orspilled into the unit. Immediately unplug the unit, and have it inspected by a
operate the unit when placed on a bed, sofa, rug, or otherservice technician. Fire and shock hazards can result from electrical shorts
soft surface.caused by liquid contact inside.
b. Avoid built-in installation, such as a book case or rack, Never drop or push any object through openings in the unit. Some internal parts
unless proper ventilation is provided.carry hazardous voltages and contact can cause electric shock or fire hazard.
Do not put any foreign object on the disc tray.
5 PLACEMENT: AVOID EXTREMELY HOT LOCATIONS OR
Avoid placing the unit directly above or below your TV set as this may cause
SUDDEN TEMPERATURE CHANGES
electrical interference. Keep all magnets away from electronic equipment.
Do not place the unit over or near heater or radiator, in direct
sunlight, inside closed vehicles, in high temperature [over 104°F5 USING ACCESSORIES
(40°C)], or in over 75% humidity. If the unit is suddenly movedUse only accessories recommended by the manufacturer to avoid risk of fire,
from a cold place to a warm one, moisture may condense in theshock, or other hazards.
unit and on the tape causing damage. Never subject the unit to6 CLEANING THE UNIT
vibration, impact, or place it so that the surface is tilted asUnplug the unit. Then, use a clean, dry, chemically untreated cloth to gently
internal parts may be seriously damaged.remove dust or debris. DO NOT USE cleaning fluids, aerosols, or forced air that
could over-spray, or seep into the unit and cause electrical shock. Any substance
6 TO AVOID PERSONAL INJURY
such as wax, adhesive tape, etc. may mar the cabinet surface. Exposure to
Do not place unsecured equipment on a
greasy, humid, or dusty areas may adversely affect internal parts.
sloping surface.
Do not place this unit on any support thatSERVICE
is not firm, level, and adequately strong.
The unit could fall causing serious injury1 DO NOT SERVICE THIS PRODUCT YOURSELF
to a child or adult and damage to the unit.If, after carefully following the detailed operating instructions, this product
does not operate properly, do not attempt to open or remove covers, or make
An appliance and cart combination should
any adjustments not described in the manual. Unplug the unit and contact a
be moved with care. Quick stops, excessive force, and
uneven surfaces may cause the appliance and cartqualified service technician.
combination to overturn.2 IF REPLACEMENT PARTS ARE REQUIRED
Carefully follow all operating instructions and use theMake sure the service technician uses only parts specified by the
manufacturer's recommended accessories when operatingmanufacturer, or those having the same safety characteristics as the original
this unit or connecting it to any other equipment.parts. The use of unauthorized substitutes may result in fire, electric shock,
or other hazards.
3 HAVE THE SERVICE TECHNICIAN PERFORM A SAFETY CHECK
After any service or repairs to the unit, request the service technician to
conduct a thorough safety check as described in the manufacturer?s service
literature to ensure that the unit is in safe operating condition.
2
AG-VP310 P1-25 (040510).p6522004/05/10, 15:01 |
ACEC
