Recording
Scene-to-scene continuity
If the unit is in the rec-pause mode, it Ensuring scene-to-scene continis possible touity at
ensure scene-to-scene continuity with an accuracy of
other times
0 up to 1 frame just by pressing the VTR START
button or lens VTR button.Proceed as follows either after the tape has been
If the unit is in a mode other than rec-pause, allowed the to pointrun or after the cassette has been ejected
at which the scene-to-scene continuity or is when to ensuring becontinuity on a tape which has been
maintained must be located before recording recorded only in part.is
started.
While monitoring the viewfinder screen, press the
1
During rec-pause
PLAY/PAUSE button to play back the tape.
The scene-to-scene continuity timing is located
automatically. However, the time taken until At the the startplace on the tape where continuity is to be
2
of recording differs depending on the setting maintained, of thepress the PLAY/PAUSE (or STOP)
VTR SAVE/STBY switch.button again to stop the tape.
OWhen the VTR SAVE/STBY switch is set to SAVE,
recording commences about two seconds after the
Press the lens RET button. It takes about two
VTR START button is pressed.3
seconds to complete the preparations for the
OWhen the VTR SAVE/STBY switch is set to STBY,
scene-to-scene continuity.
recording commences as soon as the VTR START
button is pressed.
4Press the VTR START button or lens VTR button
to start the recording.
Ensuring scene-to-scene continuity after
the power was turned off while the unit
1,23
was in the rec-pause mode
Switch the power back on.
1
2Press the VTR START button or lens VTR button
to start the recording.
4
21
69 |
ACEC
