Adjustment
Caution:4. Select [SC Fine] on the sub menu. Perform fine
Y When horizontal phase adjustment is required using RCUadjustment with the YES/ABC switch and the NO/BAR
(RCB) or hybrid control panel, BAR/CAM switch should beswitch.
set to BAR. Horizontal phase cannot be adjusted if the
switch is in the CAM position. After adjustment set
BAR/CAM switch back to CAM.
Y When horizontal phase adjustment is moved, color phase
is also moved. Adjust color phase whenever horizontal
phase adjustment is moved.
U Color phase adjustment
Supply the output signal (split color bar) from the color
special effect generator to a color monitor or vectorscope.
Adjust the color phase of the camera.
[ADJUSTMENT with RCU (RCB, Hybrid control panel)]
Use the subcarrier phase coarse adjustment control and
Color bar of camera
subcarrier phase fine control.
Sprit lineH It is recommended that a vectorscope be used for
maximum accuracy in color phase adjustment.
Color bar of special
Caution:
effects generator
Y When color phase adjustment is required using RCU
(RCB) or hybrid control panel, BAR/CAM switch should be
[ADJUSTMENT by CAMERA]set to BAR. Color phase cannot be adjusted if the switch is
1. Press the NO/BAR switch for over 5 seconds for the colorin the CAM position. After adjustment set BAR/CAM switch
bar mode.
back to CAM.
2. Select [G/L Adjustment] on the main menu, then select
Y When horizontal phase adjustment is moved, color phase
[SC Coarse] on the sub menu.is also moved. Adjust color phase whenever horizontal
3. Make coarse adjustment with the YES/ABC switch and
phase adjustment is moved.
the NO/BAR switch.
-28- |
ACEC
