Only for CQ-DP151W
EE
NN
Remote Control Unit PreparationPower and Sound Controls
GG
LL
II
SS
HBattery InstallationH
Power
Lithium battery
11 Remove the battery holder.(included)Turn the key in the ignition until the accessory indica-2
Pull the holder by the position B while pushing posi-AC C
tor lights.
Back sideON
tion A in the direction indicated by the arrow.
Power on: Press [SOURCE] (PWR).
2 Install the battery on the battery holder.
Power off: Press [SOURCE] (PWR) again and hold.
Set a new battery properly with its (i) side facing up
as shown in the Ţgure.
3 Insert the battery holder.Position B
Volume
Push in the battery holder back into its original posi-
[" VOL]: Up
tion.
[# VOL]: Down
Press and hold for rapid adjustment.
Battery holderPosition A
Battery Notes
Remove and dispose of an old battery immediately.
Battery Information:
eBattery type: Panasonic lithium battery (CR2025) (included)Volume level (0 to 40)
eBattery life: Approximately 6 months with normal use (at room temperature)
SCAN/APM
Caution:
eImproper use of batteries may cause overheating, an explosion or ignition, resulting in injury or a Ţre.RANDOM
VOLBANDCQ-DP151WCD RECEIVER 45W X4 <
Battery leakage may damage the unit.REP
PWR
SELTUNE
TRACKREMOTESOURCE
eDo not disassemble or short the battery. Do not throw a battery into a Ţre.
DISP
eKeep batteries away from children to avoid the risk of accidents.718191012LOUDMONO/LOC
MUTE123456M/L
eBe careful to the local disposal rules when you dispose of batteries.
Control Reference GuideRemote control signal sensor
Buttons of the remote control function in the same way as the controls on the main unit of the reference page.
MuteLoudness
Point the remote control unit at the main unitOs sensor (REMOTE).Press [MUTE] to mute the sound completely. Press [LOUD] to enhance bass and treble
tones at low or medium volume.
MUTE
(ATT)
LOUD
Power button (PWR)PWRMUTEMute button (MUTE)
Press [MUTE] again to cancel.
(! page 19)(! page 19)
Press [LOUD] again to cancel.
Mode button (MODE)MODE
Volume control buttons
(! pages 22, 24)
VOL)
(VOL, " #
(! page 19)
Anti-volume-blast circuit:
PRG
Band button (BAND)BAND/DISC UP
When the power is switched off and on again, the volume slowly rises to the previous level.
(! page 22)
The anti-volume-blast circuit will not work when the volume level is set lower than position 20 on the dis-
TUNEplay.
TRACK
Tune/Track buttons
(TUNE/TRACK, 6 5/% $)
(! pages 22, 25)
Car Audio
Note:
eDisc up button (DISC UP) cannot be used in this model.
1819
CQ-DP151/DP101WCQ-DP151/DP101W |
ACEC
