1 &464"
�?´
How to remove the built-in� Use only the included shaverSpecifications
charging adaptor RE3-98 to chargePower source: 100-120V AC, 50-rechargeable battery (s) before
disposal of the shaver
the ES4025/ES4026/ES4027
60 Hz
(see fig. 8)
shaver.Motor voltage: 1.2 V DC
The battery (s) in this shaver is not
� Dry the shaver completely before
Charging time: 8 Hours
intended to be replaced by consum-
setting it in the charging adaptor.
ers. However, the battery (s) may be
� Keep the charging adaptor away
This product is intended for house-
replaced at an authorized service
from water and handle it only withhold use only.
center. The procedure described be-
dry hands. Do not use an extension
low is intended only for removal of
cord to connect the charging adap-READ ALL INSTRUCTIONS
the rechargeable battery (s) for the
tor to an outlet.BEFORE USE.
purpose of proper disposal.
� The shaver may not immediately
begin to charge after being placed
WARNING:
Do not attempt to replace the bat-into the charging adaptor after use.
Allow the shaver to sit in the charg-
tery (s) for the purpose of reusing
the shaver. This could result in theing adaptor for a few minutes and
check again to make sure that it is
risk of fire or electric shock.
being charged.
� The outer foil is very thin. If han-
1. Remove the protective cap, outer
foil frame and inner blades.dled improperly, it can be easily
damaged. To avoid personal injury,
2. Remove the 2 screws (a) on the
top.do not use the shaver if it has a
damaged foil or inner blades.
3. Grasp the bottom of the unit and
the button area (b) located on the� Wash the shaver in tap water. Do
not use salt water or boiling water.
left and right, and pull the button
area away from the main unit.Also, do not use cleaning products
that are designed for toilets, bath-
4. Remove the 2 screws (c) located
inside the main unit�s case.rooms or kitchen appliances. Do
not submerge the shaver for a long
5. Grasp the top part (d) and bot-
tom part (e) of the main unit, andtime.
� Do not wipe any part of the shaver
pull them both out.
6. Remove the battery (f) from thewith thinner, benzine or alcohol.
Clean it by using a cloth dampened
chassis.
with soapy water.
Caution� Do not take the housing apart as
� Do not charge the shaver where thethis can affect the watertight
construction.
temperature is below 0°C (32°F) or
above 40°C (104°F), where it will� This power unit is intended to beFOR YOUR CONVENIENCE, WE HAVE ESTABLISHED A TOLL-FREE (IN
correctly oriented in a vertical or
be exposed to direct sunlight or aUSA ONLY) NATIONAL ACCESSORY PURCHASE HOT LINE AT
floor mount position.1-800-338-0552.heat source, or where there is a lot
FOR CANADA, PLEASE CONTACT ONE OF THE SALES BRANCHES
of moisture.
MENTIONED ON THE BACK PAGE.
8899 |
ACEC
