Caution To preventthat are designed for toilets, bath-Specifications
rooms or kitchen appliances. Do
personal injury or damagePower source: 100-240V AC,
not submerge the shaver for a long
50-60 Hz (Automatic voltage conver-
to the product,time.
sion)
Y Do not charge the shaver where theY Do not wipe any part of the shaver
Motor voltage: 2.4 V DC
temperature is below 5°C (41°F) orwith thinner, benzine or alcohol.Charging time: 1 Hour
How to remove the built-inabove 35°C (95°F), where it will beClean it by using a cloth dampened
rechargeable batteries beforeexposed to direct sunlight or a heatwith soapy water.
This product is intended for house-
disposal of the shaver
source, or where there is a lot ofY Do not take the housing apart as
(see fig. 11)hold use only.
moisture.this can affect the watertight con-
The batteries in this shaver are not
Y Use only the included adaptorstruction.
intended to be replaced by consum-
RE7-05 to charge the ES8151/Y Do not clean with water when the
ers. However, the batteries may be
ES8152 shaver.shaver is connected to the power
replaced at an authorized service
Y Dry the shaver completely beforecord.
center. The procedure described be-
charging it.Y Do not shave when the Osonic� vi-
low is intended only for removal of
Y Keep the adaptor away from waterbration is activated, as it may dam-
the rechargeable batteries for the
and handle it only with dry hands.age your skin.
purpose of proper disposal.
Y The charge status lamp may notY When cleaning the shaver with
1. Remove the screw (a) and the
glow for several minutes afterwater, do so with both the inner
bottom cover (b).
charging has commenced but willblades attached. (Doing so with
2. Slide the trimmer handle up until
glow if charging is continued.only one of the inner blades at-
it clicks in.
Y Grip the adaptor when disconnect-tached makes an abnormal noise
3. Remove the screw (c) and the
ing it from an AC outlet; tugging onand may damage the shaver.)
panel cover (d).
the power cord may damage it.
4. Remove the six screws (e).
Y Store the adaptor in a dry area
5. Remove the back panel (f).
where it will be protected from dam-
6. Lift the battery block (g) and re-
age.
move it from the battery terminal
Y Do not pull, twist, or severely bend
sealing (h).
the power cord.
7. Remove the batteries from the
Y Do not wrap the power cord tightly
battery block (g).
around the appliance.
WARNING:Y The linear motor of the shaver may
Do not attempt to replace the bat-start operating without the On/Off
teries for the purpose of reusingswitch on if the shaver is placed
the shaver. This could result in thenear a television, stereo, audio-
risk of fire or electric shock.visual equipment or anything that
generates strong magnetic field.
Do not place the shaver near theseFOR YOUR CONVENIENCE, WE HAVE ESTABLISHED A TOLL-FREE (IN
equipments.USA ONLY) NATIONAL ACCESSORY PURCHASE HOT LINE AT
Y Wash the shaver in tap water. Do1-800-338-0552.
not use salt water or boiling water.FOR CANADA, PLEASE CONTACT ONE OF THE SALES BRANCHES
Also, do not use cleaning productsMENTIONED ON THE BACK PAGE.
1011
1011 |
ACEC
