" F4. Make sure the hole in the blade is perfectly
CAUTION! WE RECOMMEND THE
coupled with the centering collar on the upper
USE OF ORIGINAL ACCESSORIES
plate. Tighten by turning counterclockwise. As
AND REPLACEMENTS, WHICH CAN
you tighten, hold the blade-plate assembly still
BE PURCHASED FROM
by inserting the wrench or screwdriver supplied AUTHORIZED DISTRIBUTORS. THE
in the holes provided.
USE OF OTHER ACCESSORIES AND
REPLACEMENTS INCREASES THE F5. Tap and go nylon string head
DANGER OF ACCIDENTS AND IN The nylon string head is used to cut grass and
THIS CASE THE MANUFACTURER weeds along borders or in zones with obstacles
HAS NO LIABILITY FOR DAMAGES like walls, fences or trees. It can operate in a very
TO PERSONS AND/OR PROPERTY.narrow or uneven zone. The nylon string cuts the
grass neatly without damaging the bark of the
Assembly of nylon string head and bladetrees or causing violent impact such as due to
Apply the proper guard depending on whether
the contact of a rigid blade with a hard surface.
you plan to use the grass blade or nylon string
head (see chapter: ?Application of protective Supply of the nylon string
devices on cutter?).CAUTION! The string cutting blade
" F1. Apply the nylon string head as shown in the housed in the plastic shield will cut
illustration: a) Protection flange b) Upper plate the nylon string to optimum length; a
c) Guard d) Nylon string head. Tighten by string that is too long reduces the
turning counterclockwise.rotation speed of the engine and
" F2. As you tighten, hold the nylon string head interferes with cutting efficiency, as
and plate still and insert the wrench or well as increasing the risk of injury.
screwdriver supplied in the holes in the plate
During cutting, the nylon string wears naturally
and gearbox; first turn the plate until the two
causing an increase in the speed of the engine
holes match.
and a reduced cutting capacity. When this
" F3. Apply the blade as shown in the illustration:
happens, to bring out more string bump the head
a) Protection flange b) Upper plate with blade
against the ground:
centering c) Guard d) Blade with wording and
release the throttle trigger to reduce the engine
direction arrow facing upward e) Lower plate f)
speed to less than 4000 rpm. Tap gently on the
Fixed cup g) Blade fastening nut.
ground with the button (A) as shown in the figure
F3. CAUTION! Do not use the nylon and the string will come out automatically.
string head guard extension (H) with Accelerate again.
metal blades.If the string does not come out make sure there
is still some left and try again.
G. Assembly of grips
G1. Double handled gripG2. Delta handle
The grip (A) can be adjusted to suit the needs of For your safety, fasten the delta handle in front
the operator by moving it forward or backward. of the label placed on the shaft at a distance of
Loosen the knob (C), place the handle in the at least 11 cm from the rear grip. The handle
desired position then tighten the knob (C) again.should be fastened in a comfortable working
position. The safety pole guard should be
CAUTION! The handle assembly (A)
mounted using the accessories supplied and in
can be folded parallel to the
the configuration shown in the figure, in contact
transmission shaft to facilitate
with the delta handle.
transport and storage of the
machine. Loosen the knob (C), turn
the support (B), by 90 clockwise,
fold the handle (A) in the desired
position and tighten the knob (C).
H. Starting and stopping the engine
CAUTION! First read chapter ?Safety CAUTION! Start the brush cutter in a
Precautions?flat place. During startup stand in a
stable position. Make sure the blade
or nylon string head do not touch the
ground or any obstacles.
ENGLISH - 7 |
ACEC
