T6410EZ(UK).qx3 03.3.22 14:08 Page 4
SpecificationsSupplied accessories
Voltage:220-240V/50HzY Operating instructions
Power consumption (Standbless than 5Wy):Y Remote control and batteries
Rewind time:less than 260 seconds (cassette E-180)
Number of video heads :2
Recording/playback time:3 hours (SP)
(cassette E-180), 6 hours (LP) (cassette E-180)
W eight without packing in kg:11.5
Dimensions in cm (HxWxD):40.0x37.3x38.0
Power consumption :52W
1. Connecting the TV-Video Combi
Important for the United KingdomPreparing the remote control for
This apparatus is fitted with an approvoperationed 5 Amp
plug. To change a fuse in this type of plug pro-
The remote control and its batteries are packed
ceed as follows:
separately in the original TV-Video Combi pack-
1.1.Remove fuse cover and fuse.
aging.You must install the batteries in the
2.2.Fix new fuse which should be a BS1362
remote control before use.
5A,ASTA or BSI approved type.
3.3.Refit the fuse cover.
If the fitted plug is not suitable for your socket
outlets, it should be cut off and an appropriate
plug fitted in its place.
If the mains plug contains a fuse, this should
1.Take the remote control and the enclosed bat-
have a value of 5A. If a plug without a fuse is1.
used, the fuse at the distribution board should notteries (2 batteries).
be greater than 5A.2.2.Open the remote control's battery compart-
ment and place the batteries in it as shown in
The severed plug must be destroyed to avoid a pos-the picture and close the battery compartment.
sible shock hazard should it be inserted into a 13A
The remote control is now ready to use.
socket elsewhere.
Its range is approximately 7 metres.
How to connect a plug:
The wires in the mains lead are coloured in accor-
Connecting the cable
dance with the following code:
BLUE- 'NEUTRAL' ('N')
BROWN- 'LIVE' ('L')
4.4.The BLUE wire must be connected to the termi-
nal which is marked with the letter 'N' or
coloured BLACK.
5.5.The BROWN wire must be connected to the
terminal which is marked with the letter 'L' or
coloured RED.
6.6.Do not connect either wires to the earth termi-
1.1.Insert the aerial cable plug into the AERIAL at
nai in the plug which is marked with the letter
'E' or by the safety earth symbol or colouredthe back of the TV-Video Combi.
green or green-and-yellow.2.2.Connect the mains cable to the wall socket.
Before replacing the plug cover, make cer3.3.tain thatIf the little red standby light (STANDBY ) at
the cord grip is clamped over the sheath of thethe front panel of the set is not lit, please
lead-not imply over the two wires.switch on the set using the main power
switch. The power switch is located on the
left side panel of the set.
EN
4 |
ACEC
