Connecting to the aerialNote:
* We advise you, from now on, to switch the set
to standby using theSTANDBY mbuttonon
You can use the auxiliary aerial supplied or connect
the set to your aerial installation.the front of the set or on the remote control.
When the set is in the standby mode, a small red
1Inserttheaerialplugintothe2socket.lamp on the left of the front of the set will be
alight.
You can switch on withSTOP h,the0-9
buttons or by inserting a cassette.
Attention: When you use the power switch
8onthesidepanel,youhavecompletely
switched off the set from the mains power
supply. No programmed recordings will then be
made. The red lamp on the left of the front of
the set will not be alight. After a few hours, the
date and clock settings will be lost.
Attention: Before you switch off the appliance
with the power switch8,removethetape
by pressing theJbutton.
* Keep your TV Combi connected to the mains
2Ifyouusetheauxiliaryaerialsupplied,pushtheand the power switch in on position at all times
aerial into the mounting on the back panel until itto ensure that programmed recordings can be
snaps into place. Rotate the aerial until you have
got the best picture quality.made and that the television functions. The
power consumption required for this is very low.
Connecting to the mains power sup-
Connecting a decoder or other addi-
ply
tional equipment
1Inserttheplugofthemainscableintothewall
socket.
You can also connect additional equipment to the
EXTERNALsocket,forinstance,aCD-Interactive
(CD-i), satellite receiver or camcorder.
Some TV broadcasters transmit encoded television
programmes which you can only see with a
purchased or rented decoder. You can connect such
a decoder (descrambler) to this set.
2Switchtheseton.Thepowerswitch8is
located on the left side panel of the set.
5 |
ACEC
