How to Use the On Screen Display (OSD)
Geometry Controls window
Pincushion, Balanced Pincushion, Balanced Pincushion,Pincushion,
TTrrapezoid, apezoid, PPararallelograllelogram, am, RRototaationtion
Follow the steps below to adjust any of the five preset options (PINCUSHION, BALANCED PINCUSHION, TRAPEZOID,
PARALLELOGRAM, or ROTATION). You can make individual adjustments to each of the preset options. Note: use these
features only when the picture is not square.
1Press the ON SCREEN1
DISPLAY button.
mainAMIN CONTROLSscreen
geometryEXITcolor
advnacedRESETspecial
16001x200 106.3K/85HZ
PINCUSHION
ma i ns
2b2bPress the ON
MAIN CONTROLS
mainscreenSCREEN DISPLAY
geome t ryEXITbutton.Then, turn
geometryEXITcolor
the ROTARY knob to
RESETRESET
advancedspecial2a2aadjust the
Turn the ROTARY knob until the GEOMETRYadvancedsp
pincushion.
CONTROLS window is highlighted. Next,
1600x1200 106.3K/85HZ
press the ON SCREEN DISPLAY button.PINCUSHION
Then, if necessary, turn the ROTARY knob until PINCUSHION icon
is highlighted.50%
2c2cWhen done,press
the ON SCREEN
PARALLELOGRAM
To select PARALLELOGRAM orDISPLAY button to
5a5a
ROTATION, turn the ROTARY knobsave the change
50%
until PARALLELOGRAM or ROTATIONand return to
GEOMETRY CONTROLS
5bicon is highlighted. Next,5b
press the ON SCREEN DISPLAYwindow.
ROTATION
button.Then follow steps 4b
5c5cand 4c to make the
50%
appropriate changes.
3a3aTo select BALANCED
PINCUSHION, turn the
ROTARY knob until
BALANCED PINCUSHION
4c4cis highlighted. Next,When done, press the
ON SCREEN DISPLAY button.
press the ON SCREEN
This will save the
DISPLAY button.
change and return the
screen to GEOMETRY
CONTROLS window.
BALANCED PINCUSHION
TRAPEZOID
50%
50%4a4aTo select3c3cWhen done,3b3b
4b4bTurn the ROTARY knob (on
TRAPEZOID, turn the
press the ON
Turn the ROTARY knob toROTARY knob untilthe lower right-hand corner of
SCREEN DISPLAY
adjust the trapezoid.TRAPEZOIDIcon isthe monitor) to adjust the
button.This will
highlighted. Next,balanced pincushion.
save the change
press the ON
and return the
SCREEN DISPLAY
screen to
button.GEOMETRY
CONTROLS.
Smart Help
To exit GEOMETRY CONTROLS . . .
. . . but continue to another window, turn the ROTARY knob until EXIT is highlighted. Next, press the ON SCREEN DISPLAY button.Then, turn the ROTARY knob
until that window is highlighted. Now, press the ON SCREEN DISPLAY button and follow the instructions for that window.
. . . completely, press the ON SCREEN DISPLAY button and hold for 1.5 seconds.The On Screen Display will disappear.All changes will be saved.
To make changes to one item, follow the steps for that item.Then, follow OTo exit GEOMETRY CONTROLS . . . .�
To return to factory presets, see OTo Reset an Individual Window� on page 15.
14 |