T6460EZ(EN)_UK.qx3 04.1.28 1:19 PM Page 15
9. Before you call an engineer
If, contrary to expectation, you have any prob-
lems using this TV-Video Combi, it may be
caused by the following reasons.
Your TV-Video Combi does not respond tomagnetism might affect the colour of the TV
any button being pressed:picture. Move the TV-Video combi away from
Y There is no power supply: Check the powersuch sources. The TV-Video combi will read-
supply.just itself automatically. If you want to initiate
YParental control is on:switch the parental con-an immediate readjustment, unplug the TV-
trol off.Video combi from the mains and plug it in
YA programmed recording is currently beingagain approximately 30 minutes later.
made: If desired, cancel the programmedNo recording possible:
recording. Please see the section 'Problems
Y The TV channel you want to record is not
and solutions for programmed recordings' in
stored or you selected the wrong programme
chapter 'Programming a recording (TIMER)'.
number: Check TV channels stored.
Y There is a technical problem: disconnect from
Y A cassette was inserted that does not have the
the mains power supply for 5 minutes, then
security tab (cannot be used to record): Cover
power-up again.
the hole with adhesive tape or use a cassette
If this doesnOt help, you could reset your TV-
with an intact security tab. For more informa-
Video Combi to the default factory settings.
tion, please see the section 'Preventing acci-
Resetting devices to default factory settings
dental erasing' in chapter 'Manual recording'.
* Attention: All the information stored (time and
date, TIMER) will be cleared.
1.Switch the TV-Video Combi to stand-by.[14PV235 / 21PV385]
2.Press and hold REC I and PROG P+ at theNo recording possible:
same time for 2 seconds or more.Y 'PDC' switched on but 'PDC time' wrong: Enter
Cassette is jammed in the TV-Video Combi:'PDC time' exactly to the minute. Have your
Y DonOt use force. Pull out the mains plug for theaerial checked.nel on �P01O with good FAST-
moment. Then, call an engineer.TEXT reception.
Remote control does not work:YYou have not activated the Smart Clock func-
Y Remote control not pointed toward the TV-tion. Switch the function �ONO.
Video Combi: Point it at the TV-Video Combi.Smart Clock does not work:
Y There is a technical problem:Take out the bat-Y You have stored on programme number �P01O a
teries, wait for 10 seconds and place themTV channel that does not transmit FASTTEXT.
back.Store on �P01O a TV channel that transmits
Y Batteries have run out: Change the batteries.FASTTEXT.
No picture when you play back a cassette:YPoor FASTTEXT reception. Store a TV chan-
Y There is no recording on the cassette: Changenel on �P01O with good FASTTEXT reception.
the cassette.YYou have not activated the Smart Clock func-
Poor picture quality when you play back ation. Switch the function �ONO.
cassette:
YYour TV is not properly adjusted.You can also call the customer service centre
Y The cassette is badly worn or of poor quality:in your country.
Use new cassette.The telephone numbers can be found on page
YTracking is not properly adjusted: Turn to sec-16 of this operating manual. Have the model
tion 'Manual tracking'.number (MODEL NO.) and the production num-
Y Magnetism from nearby appliances and geo-ber (PROD. NO.) of your TV-Video Combi ready.
EN
15 |
ACEC
