T6460/550/552EZ(EN)_EST.qx3 04.1.28 4:15 PM Page 4
Specifications21PV385
Power consumption: 65W
Voltage: 220-240V/50HzDimensions in cm (HxWxD): 51.2x51.0x49.5
Power consumption (Standby): less than 5W
Rewind time: less than 260 seconds Weight without packing in kg: 20.6
(cassette E-180)
Number of video heads: 2Supplied accessories
Recording/playback time:Y Operating instructions
3 hours (SP) (cassette E-180)Y Remote control and 2 batteries
6 hours (LP) (cassette E-180)
14PV135 14PV235
Power consumption: 52W
Dimensions in cm (HxWxD): 40.1x37.9x38.0
Weight without packing in kg: 10.5
1. Connecting the TV-Video Combi
4.4.Language setting picture will appear on the
Preparing the remote control for
operationscreen.
The remote control and its batteries are packed
separately in the original TV-Video Combi pack-
aging.You must install the batteries in the
remote control before use.
PUSH MENU TO CONTINUE
I do not see a Language setting picture
1.1.Take the remote control and the enclosedY Check the cable connections.
batteries (2 batteries).
You can find more details in chapter �Preparation
2.2.Open the remote controlOs battery compart-for useO.
ment and place the batteries in it as shown in
the picture and close the battery compart-
ment.Connecting additional devices
The remote control is now ready to use. Its
range is approximately 7 metres.You can connect addi-
tional devices such as
Connecting the cabledecoders, satellite
receivers, camcorders,
1.1.Insert the aerialetc. to the EXT1/AV1
cable plug intosocket.
the AERIAL atThe respective scart socket is usually marked
the back of the�AVO or �TVO on the decoder or satellite receiver.
TV-Video Combi.Selection of the scart socket
2.2.Connect theY To select the Scart socket, please enter 0,0,1,
mains cable to
the wall socket.with the keys 0..9 on the remote control. AV1
3.3.If the little red standby light (STANDBY ) atappears on the screen.
Selection of the front A/V sockets
the front panel of the set is not lit, pleaseY To select the front A/V sockets, please enter
switch on the set using the main power
switch. The power switch is located on the0,0,2, with the keys 0..9 on the remote control.
left side panel of the set.�AV2O appears on the screen.
EN
4 |