Information for users in the UK (not Important
applicable outside the UK)This apparatus is tted with an approved
moulded 13 AMP plug. Should it become
Positioning the TVnecessary to replace the mains fuse, this
For the best results, choose a position must be replaced with a fuse of the same
where light does not fall directly on the value as indicated on the plug.
screen, and at some distance away from
radiators or other sources of heat. Leave 1 Remove fuse cover and fuse.
a space of at least 5 cm all around the TV 2 The replacement fuse must comply with
for ventilation, making sure that curtains, BS 1362 and have the ASTA approval
cupboards etc. cannot obstruct the air ow mark. If the fuse is lost, make contact
through the ventilation apertures. The TV is with your retailer in order to verify the
intended for use in a domestic environment correct type.
only and should never be operated or stored 3 Ret the fuse cover.
in excessively hot or humid atmospheres. If for any reason the tted plug is not
suitable for your socket outlet, please
General Points consult your retailer or a qualied
Please take note of the section entitled Tips electrician before proceeding with the
at the end of this booklet. installation.
InterferenceConnecting the aerial
The Department of Trade and Industry The aerial should be connected to the
operates a Radio Interference Investigation socket marked : at the back of the set.An
Service to help TV licence holders improve inferior aerial is likely to result in a poor,
reception of BBC and IBA programmes perhaps unstable picture with ghost images
where they are being spoilt by interference.and lack of contrast. Make-shift loft or set-
If your dealer cannot help,ask at a main Post top aerials are often inadequate. Your dealer
Ofce for the booklet How to Improve will know from experience the most suitable
Television and Radio Reception.type for your locality. Should you wish to
use the set in conjunction with
Mains connectionother equipment, which connects to the
Before connecting the TV to the mains, aerial socket such as TV games, or a video
check that the mains supply voltage cor-camera it is recommended that these be
responds to the voltage printed on the connected via a combiner unit to avoid
type plate on the rear panel of the TV. If repeated connection and disconnection
the mains voltage is different, consult your of the aerial plug.
dealer.
Fitting the stand (if provided)
Use only the stand provided with the set,
making sure that the xings are properly
tightened. A diagram showing how to
assemble the stand is packed with the stand.
Never use a make-shift stand, or legs xed
with woodscrews. |