To select connected equipment
If the TV is connected to a video recorder with the EasyLink function,in some cases
the TV will be switched on,even when it was in standby.(E.g.playback tape,...)
This is not possible when Child lock On is selected.
Equipment connected with an aerial cable only :
798
E
Select the programme number under which you have stored the test signal
i00
with the digit keys.
XSb
SMART
wMaqEquipment connected to a euroconnector or to the right side of
hthe TV
ACTIVE CONTROL
wPress the w key repeatedly to select EXT1,EXT2,EXT3 or FRONT,
according to where you connected your equipment at the back or the right
side of your TV.
Remark :Most equipment (decoder,video recorder,satellite receiver) carries out the
switching itself.
If you want to change to TV channels?
Enter the programme number of the TV channel which you want to watch
with the digit keys or press the w key repeatedly to select TV.
B
Audio and video equipment keys
B
INSTANTQ
?O!A
?Most of the audio and video equipment from our range of products can be
y�
Ufhoperated with the remote control of your TV.
O
ab
MENUOK
!Video recorder
AKeep the VCR key on the left side of the remote control pressed and
simultaneously press:
VP?for record,
?
Ofor rewind,
132
!for stop,
465
798Afor play,
E
i00 for fast forward,
E
XSbEfor selecting 1- or 2-digit programme numbers from the video
SMART
wMaqrecorder,
h
- P +for sequential programme selection from the video recorder tuner,
ACTIVE CONTROL
0 to 9 to select a programme number from your video recorder tuner,
Bto switch the video recorder to standby
These keys function with equipment which use the RC5 signalling standard.
If your video recorder has the EasyLink function,the key INSTANT ? for recording,
can be operated in the TV mode.
If your EasyLink video recorder has the system standby function,when you press the
B key for 3 seconds,both TV and the video recorder are switched to standby.
Connect Peripheral Equipment23 |
ACEC
