2144.2 gb 07-06-2002 15:47 Pagina 19
Connect Peripheral Equipment
There is a wide range of audio and video equipment that can be connected to your TV.
The following connection diagrams show you how to connect them.
RecorderConnect the aerial cables 1, 2 and, to obtain the optimum picture quality, eurocable 3
as shown.
If your recorder is provided with the EasyLink function,the eurocable supplied with it should be
CABLEconnected to EXTERNAL 2 to benefit from the EasyLink functionality.
If the eurocable 3 is not used the following steps are required:
2
EXT.
1Search for and store the test signal of the recorder
2&Unplug the aerial cable 1from the aerial socket xof your recorder.
éSwitch on your TV and put the recorder on the test signal.(See the handbook for your3
recorder.)
Search for the test signal of your recorder in the same way as you searched for and
4
stored the TV signals. See Installation, Store TV channels, Manual Installation, p. 8.
VCR 1
Store the test signal under programme number 0 or between 90 and 99.
(Replace the aerial cable in the aerial socket xof your recorder after you have stored
the test signal.
Decoder and Recorder
Connect a eurocable 4 to your decoder and to the special euroconnector of your
recorder. See also the recorder handbook. See Decoder, p.11.
You can also connect your decoder directly to EXTERNAL 1 or 2 with a eurocable.
Other equipment (except Digital Sources)
&Connect the aerial cables 1,2and 3as shown.Better picture quality can be
obtained if you also connect eurocable 5 to EXTERNAL 2 and a eurocable 4 to
CABLE
EXTERNAL 1or 3.
éLook for the test signal of your peripheral in the same way as you do for a recorder.
When a recorder is connected to EXTERNAL 1 you can only record a programme from your TV.
1Only when a recorder is connected to EXTERNAL 2 it is possible to record a programme from
EXT.1
2
your TV as well as from other connected equipment.See Record with your recorder,p.22.
Note:EXTERNAL 1 can handle CVBS and RGB,EXTERNAL 2 CVBS and Y/C,EXTERNAL 3
4
3 5
2CVBS and RGB.It is preferred to connect peripherals with RGB output to EXTERNAL 1 or 3 as
RGB provides a better picture quality.
VCR 1
Side connectionsCamera or Camcorder
&Connect your camera or camcorder to sockets at the right side of your TV.
éConnect the equipment to VIDEO2and AUDIO L3for mono equipment.
For stereo equipment also connect AUDIO R3.
SYVIDEO
VIDEO
AUDIO
S-VHS quality with an S-VHS camcorder is obtained by connecting the S-VHS cables
with the S-VIDEO input 1 and AUDIO inputs 3.
Do not connect cable 1 and 2 at the same time.This may cause picture distortion !
123
Headphone
&Insert the plug into the headphone socket Lat the right side of the TV.
éPress ?on the remote control to switch off the internal loudspeakers of the TV.
The headphone impedance must be between 8 and 4000 Ohm.The headphone socket has a
3.5 mm jack.
In the SOUND menu select Headphone volume to adjust the headphone volume.
Note:The surround mode is always stereo when the headphone is connected.
Connect Peripheral Equipment19 |
ACEC
