2330.4 gb 06-09-2004 15:22 Pagina 7
How to search for and store TV channels
ViaVia the TV menu:
&Press the MENUkey on the remote control.
Keep the MENU/OK key on top of
éUse the cursor up/down to select Install.
the TV pressed for 5 seconds to
ŤPress the cursor right to enter the Install menu.
start the Plug & Play installation.
Select your country and language.ŹUse the cursor left/right to select your language.
Tuning starts automatically.(Press the cursor down to select Country.
§Use the cursor left/right to select your country.
Note:Select O.....� when none of the countries applies.
TV MenuAuto StoreInstallInstall
LanguageSystem
PicturePrLanguageogrammeA ..........Language ....
CountrySearch
SoundCountrTVyAfreqCountry 10 p
Auto StoreProgram No
FeaturesAuto StoroeAuto Store 11
Manual Store A Fine tune
Install AManp ual Stor AeManual Store 12 A
�SortStore
ModeSortSort A 13
Auto storeManual store
&Select Auto Storein the Install menu.Searching for and storing TV channels is done
The autostore option label Start appears.channel by channel.You must go through every step
of the Manual Installation menu.
éPress the cursor right.
ŤThe progress of autoprogramming is displayed.&Select Manual Storein the Install menu and
press the cursor right to enter.
If a cable system or a TV channel which broadcasts
éSelect the TV system:
ACI (Automatic Channel Installation) is detected, a
Select the country or part of the world from
programme list appears.Without ACI broadcast,
where you want to receive the TV channel. If
the channels are numbered according your
you are connected to a cable system, select
language and country selection.You can use the
your country or part of the world where you
Sort menu to renumber them.
are now located.
It is possible that the cable company or the TV channelNote:for automatic detection select Europe (except
displays a broadcast selection menu.Layout and itemsfor France).
are defined by the cable company or the TV channel.
ŤSearch for a TV channel:
Press the cursor down to select Search and
Sorting TV channelspress the cursor right to start searching.
&Select Sortin the Install menu and press the
Direct selection of a TV channel:
cursor right
If you know the frequency,enter it directly with the
éSelect the TV channel you want to move usingdigit keys 0 to 9.Ask for a list from your cable
the cursor up/down and press cursor right.company or dealer,alternatively consult the Table of
ŤSelect the new number and validate with thefrequencies on the inside backcover of this
cursor left.handbook.
ŹRepeat steps éand Ťfor each TV channelŹPress the cursor down and enter the
you wish to renumber.programme number with the digit keys.
(To exit the menus,press the MENUkey(Fine tune:
repeatedly.In case of poor reception, you can improve the
reception by adjusting the frequency with the
cursor left/right.
§To store your TV channel,select Storeand
press the cursor right. Repeat steps Ť to (
to store another TV channel.
eTo exit from the menu press the MENUkey on
the remote control.
7 |
ACEC
