BASIC ANTENNAAND CABLE CONNECTIONS
4
our homeOs signal input might comeAntenna Connection
Yfrom a single (75 ohm) round cable,
a Converter Box, or from an antenna.
In either case the connection to the TV
is very easy.
Combination
If your Cable TV signal orVHF/UHF Antenna
Antenna signal is a round cable(Outdoor or Indoor)
1(75 ohm) then you're ready to
connect to the TV. 300 to 75 ohmBack of TV
If your antenna has flat twin-Adapter
lead wire (300 ohm), you first
need to attach the antenna wires
to the screws on a 300 to 75 ohm
adapter.
If you have a Cable Converter
Twin Lead
Box: Connect the Cable TV sig-Wire
nal to the Cable Signal IN(put)
plug on the Converter.
Connect the Cable TV cable orRound Cable
Antenna cable (or 300 to 75 ohm75 ohm
2
adapter) to the 75 ohm plug on the
TV.
If you have a Cable Converter
Box: Connect the OUT(put) plug
from the Converter to the 75 ohm
plug on the TV.
our Cable TVinput into your
Direct Cable Connection
Yhome may be a single (75 ohm)
cable or use a cable box decoder. In
either case the connection is very
simple. Follow the steps below toCable signal
connect your cable signal to yourcoming from
Cable Company
new television.
This connection will supply Stereo
Back of TVsound to the TV.
Connect the open end of the
round Cable Company supplied
1
cable to the 75 ohm input on the
TV. Screw it down finger tight.
75 ohm Round
Coaxial Cable
HELPFULHINT
After using the AutoProgram Control,Jack Panel
press the CH + and � buttons to scrollBack of TV
through all the channels stored in the
televisionOs memory.
175 |