BASIC ANTENNA TELEVISION CONNECTION
combination antenna receives normalAntenna Connection:
Abroadcast channels (VHF 2�13 and
Outdoor or Indoor Antenna
UHF 14�69). Your connection is easy
(Combination VHF/UHF)
because there is only one 75& (ohm)
The combination antenna receives normal
antenna plug on the back of your TV, andbroadcast channels 2-13 (VHF) and 14-69 (UHF).
thatOs where the antenna goes.
If your antenna has a round cable
1
(75 ohm) on the end, then you're ready
1
300 to 75-ohm
to connect it to the TV.
Adapter
If your antenna has flat, twin-lead
wire (300 ohm), you first need to
2
attach the antenna wires to the screws
Twin
on a 300- to 75-ohm adapter.
Lead Wire
Push the round end of the adapter (orANT 75?VIDEOMonitor outYAV1 inAV2 in
L/MonoAUDIORPbS-VIDEO
Pr
antenna) onto the 75& (ohm) plug onCOMPONENT VIDEO INPUT
2
the back of the TV. If the round end ofJack Panel
Back of TV
the antenna wire is threaded, screw itBack of TV
down finger tight.
Round 75&
Coaxial Cable
from Antenna
cc CHECK IT OUT
After using the AutoProgram Control, press
the CH + and � buttons to scroll through all
the channels stored in the televisionOs memory.
BASIC CABLE TELEVISION CONNECTION
our Cable TVinput into your home may
Direct Cable Connection:
Ybe a single (75 ohm) cable. If so, this con-
nection is very simple. Follow the steps below
BACK OF TV
to connect your cable signal to your new tele-
Cable signal coming
vision.
from Cable
1
Company (Round
Direct Cable Connections:
75& coaxial cable)
Connect the open end of the round
Cable Company supplied cable to theANT 75?L/MonoVIDEOMonitor outAUDIOYRCOMPONENTPbPr VIDEO INPUTS-VIDEOAV1 inAV2 in
1
75& input on the TV. Screw it down fin-
ger tight.Jack Panel Back of TV
7 |
ACEC
