2224.1 gb 11-02-2003 08:55 Pagina 14
Connect Peripheral Equipment
There is a wide range of audio and video equipment that can be connected to your TV.
The following connection diagrams show you how to connect them.
Note:EXT.1can handle CVBS and RGB,EXT.2CVBS and Y/C.It is preferred to connect peripherals with RGB
output to EXT.1as RGB provides a better picture quality.
If your recorder is provided with the Easylink function,it should be connected to EXT.2to benefit from the EasyLink
functionality.
Recorder (VCR-DVD+RW)
Connect the aerial cables 1, 2 and, to obtain the optimum
picture quality, eurocable 3 as shown.
CABLEIf your recorder does not have a euroconnector, the only possible
connection is via the aerial cable.You will therefore need to tune in
your recorderOs test signal and assign it programme number 0 or
2
EXT.store the test signal under a programme number between 90 and
199, see Manual installation, p. 6.
See the handbook of your recorder.
2
3Decoder and Recorder
Connect a eurocable 4 to your decoder and to the special
euroconnector of your recorder. See also the recorder handbook.
4
See Decoder, p. 8. You can also connect your decoder directly to
EXT. 1or 2with a eurocable.
Other equipment (satellite receiver,decoder,DVD,games,etc.)
&Connect the aerial cables 1,2and 3as shown (only if
your peripheral has TV aerial in-/output).
CABLEConnect your equipment with a eurocable 4 or 5 to one of
the euroconnectors EXT.1 or 2 to obtain a better picture
quality.
1éLook for the test signal of your peripheral in the same way as
1EXT.
2you do for a recorder.
Make a selection in the Setup,Source menu,p.8.
4
3 5
2
Side connectionsCamera or Camcorder
&Connect your camera or camcorder as shown.
éConnect to VIDEO2and AUDIO L3for mono equipment.
For stereo equipment also connect AUDIO R 3.
S-VHS quality with an S-VHS camcorder is obtained by
connecting the S-VHS cables with the S-video input 1 and
2audio inputs 3.
Do not connect cable 1 and 2 at the same time.This may cause
3picture distortion !
Headphone
1
&Insert the plug into the headphone socket Las shown.
éPress ?on the remote control to switch off the internal
loudspeakers of the TV.
The headphone impedance must be between 8 and 4000 Ohm.The
headphone socket has a 3.5 mm jack.
In the Sound menu select Headphone volume to adjust the
headphone volume.
14 |
ACEC
