3104 305 4700.5.gb 27-05-1999 11:33 Pagina 12
SOUND Dolby* Pro Logic
J Dolby Pro Logic Dolby Pro Logic
VolumeAdjust the volume balance level of the loudspeakers
Graphic Equalizer
Most programmes will sound good with the volume balance between the
Loudness
centre left and right and rear loudspeakers in an equally loud position.
Headphone
However, some programmes may benefit from an adjustment of the level of
the respective speakers.
Which loudspeakers are active depends on the Surround Mode selection you
make below.
Dolby Pro Logic
& Select Pro Logic in Surround Mode of the DOLBY PRO LOGIC menu.
LeftRight
Ž Select Start Test and press the OK key.
A steady noise tone is switched sequentially through the left, centre, right and
Centre
rear loudspeakers, for 2 seconds each. This enables you to adjust the volume
RearRearof the separate loudspeakers.
The loudspeakers activated light up in the on screen graphic.
J Start Test Start Test
Stop Test O Select Centre Volume, Balance or Rear Volume and alter the selected
Centre Volume
adjustments.
Balance
Rear Volume� Select Stop Test in the DOLBY PRO LOGIC menu and press the OK key when
Surround Modeyou have finished the adjustments of the level of the speakers.
Surround mode
Select the Dolby Surround Sound mode according to the sound mode being
broadcast.
Pro Logic (with Dolby Surround broadcasting)
In addition to the left and right front speakers, the centre and the rear
surround loudspeakers reproduce the Dolby Surround Pro Logic sounds.
Pro LogicThis 4-channel sound is always recorded when the movie or programme is
marked with Dolby Surround.
This mode is especially recommended for such programmes as movies.
Dolby 3 Stereo (with Dolby Surround broadcasting)
The Dolby 3 Stereo sound signal is now distributed over the front left, the
front right and the centre loudspeakers.
The rear loudspeakers do not produce any signal.
Dolby 3 Stereo
Hall (with Dolby Surround broadcasting)
The centre sound signal is distributed over the rear loudspeakers which
creates a hall effect from the rear.
The centre loudspeaker does not produce any signal.
This mode is recommended when you wish to add surround sound to a
broadcast which is not encoded Dolby Surround.
Hall
Off
This mode reproduces only the left and right front sound signals.
You only hear a stereo sound if the broadcast which you are watching or
listening to is transmitted in stereo or digital sound.
YPress the green MENU key to return to the SOUND menu.
Off
*�DolbyO �Pro LogicO and the double-D symbolare trademarks of Dolby
Laboratories Licensing Corporation.
12Manufactured under license from Dolby Laboratories Licensing Corporation. |
ACEC
