2394.3 en 06-09-2004 10:56 Pagina 19
AV3/AV4 Digital High Definition input
Connect the equipment with 2 Fh RGB output to
the RGB connector and to the L and R AUDIO
YRGB Y
jacks of AV3.
AUDIOAUDIO
PbLPbLConnect the equipment with 2Fh YPbPr output to
the Y,Pb and Pr jacks and to the L and R AUDIO
PrRPrR
jacks of AV4.
VIDEO 2Fh
480p/1080iSee also the manual of your High Definition
AV 4AV 3equipment.
ININ
Inputs AV3 and AV4 also allow horizontal and
AV3/AV4 input connectors will accept the
vertical picture shift using the remote control
following signals from HD set top box (HD-STB)
cursor left/right, up/down.
decoders and progressive scan DVD players:
ED 480p31.470 kHz60 Hz
Note:
HD 1080i33.750 kHz60 Hz
- 60 Hz normally refers to USA markets and 50 Hz
HD 576p31.250 kHz50 Hz
to UK,Europe and Australian markets.
- The AV3 RGB (D-15) connector will accept only the
AV3/AV4 input connectors also accept the
signal standards 480p/60 Hz,1080i/50 Hz and
following 1250 line HD display formats (available
1152i/50 Hz and is only for TV standards.
on selected HD-STB decoders) as detailed in the
It is not a PC connector.
Australian DTV Receiver Standards:
HD 1152i (1250) 31.250 kHz 50 Hz
Warning:in case you notice scrolling images,wrong
HD 1080i (1250) 31.250 kHz 50 Hz
colours or no colour,no picture,or even combinations of
these on your screen,check if the connections are done
in the right way.
Side connectionsCamera or camcorder
&Connect your camera or camcorder to sockets at the
right side of your TV.
SYVIDEOéConnect the equipment to VIDEO2and AUDIO L
VIDEO
AUDIO3 for mono equipment. For stereo equipment also
connect AUDIO R 3.
S-Video quality with an S-VHS, Hi-8 or Digital
camcorder is obtained by connecting the
S-Video cables with the S-VIDEO input 1 (instead of
123
VIDEO2) and AUDIOinputs 3.
Note:If you prefer,you can also connect the camcorder to
one of the TVOs rear av in jacks.
Headphone
&Insert the plug into the headphone socket Lat the
right side of the TV.
éPress ?on the remote control to switch off the
internal loudspeakers of the TV.
The headphone impedance must be between 8 and 4000
Ohm.The headphone socket has a 3.5 mm jack.
In the Sound menu select Headphone volume to
adjust the headphone volume.
When the headphone is connected, the surround mode
is always stereo.
19 |