2134.1 gb 23-01-2002 16:25 Pagina 25
Connect Peripheral Equipment
There is a wide range of audio and video equipment that can be connected to your TV.
The following connection diagrams show you how to connect them.
Video recorder
Connect the aerial cables 1, 2 and, to obtain theDecoder and video recorder
optimum picture quality, eurocable 3 as shown below.Connect a eurocable 4 to your decoder and to the
special euroconnector of your video recorder. See also
the video recorder handbook.
See Define Decoder/Descrambler prog. numbers, p. 8.
CABLEYou can also connect your decoder directly to
EXTERNAL 1or 2with a eurocable.
2
EXTERNAL
1Video recorder and other equipment
(except Digital Sources)
2
3
CABLE
4
VCR 1EXTERNAL
1 2
13
If your video recorder is provided with the EasyLink function,the
eurocable supplied with it should be connected to
EXTERNAL 2to benefit from the EasyLink functionality.45
2
If the eurocable 3 is not used the following steps are
required:
VCR 1
Search for and store the test signal of the video
recorder
&Unplug the aerial cable 1from the aerial socket xof&Connect the aerial cables 1,2and 3as shown.
Better picture quality can be obtained if you also connect
your video recorder.
eurocable 5 to EXTERNAL 2 and a eurocable 4 to
éSwitch on your TV and put the video recorder on the testEXTERNAL 1,3or 4.
signal. (See the handbook for your video recorder.)
éLook for the test signal of your peripheral in the same
Search for the test signal of your video recorder in the
way as you do for a video recorder.
same way as you searched for and stored the TV signals.
See Installation, Searching for and storing TV channels,When a video recorder is connected to EXTERNAL 1you can
Manual Installation, p. 6.only record a programme from your TV.
Only when a video recorder is connected to EXTERNAL 2it is
Store the test signal under programme number 0 or
possible to record a programme from your TV as well as from
between 90 and 99.
other connected equipment.See Record with your video
(Replace the aerial cable in the aerial socket xof yourrecorder,p.31.
video recorder after you have stored the test signal.
Note:EXTERNAL 1 can handle CVBS and RGB,EXTERNAL 2
CVBS,Y/C and RGB,EXTERNAL 3 and 4 only CVBS.
It is preferred to connect peripherals with RGB output to
EXTERNAL 1or 2as RGB provides a better picture quality.
Connect Peripheral Equipment25 |
ACEC
