Notes:
? When you have locked TV channels while initiating autoprogram, a message appears asking to enter your PIN code in order to complete autoprogramming.
? When interrupted, the updated channel information is retained as well as the not yet updated old channel information.
? Background autoprogramming occurs only when the TV is turned on.
? Channel information of an ATSC channel is updated only for the ATSC channel currently tuned.
? If an NTSC channel is tuned, then in Background Autoprogramming the TV shall scan all the possible ATSC frequencies and update information.
? Weak channel installation : This allows you to manually tune weak ATSC channels in order to adjust the antenna and thus optimize signal quality for that
channel.
? Once you have searched for the available Antenna as well as the Cable TV channels, they are stored in the memory.
Channel tuning
Available channels:
- Cable (analog NTSC or digital QAM): max. from 1 to 125
Note: Digital Channel selection delay
- Antenna (analog NTSC or digital ATSC): max. from 2 to 69
Due to the tuning complexity of subchannel digital
If a tuned channel is not yet in the master channel map, the TV will attempt
programming, the time to select and view a digital
to tune the channel and it will be added to the map.
channel may take slightly longer than what the viewer
If the channel is not acquired, a message will appear that the channel is not
is normally accustomed to (as compared to analog
available.
channel programs).
When you tune an audio-only digital subchannel, a display appears with the EnglishDigital channel broadcasts contain program and
system data information that must be processed message Audio only.
before the channel selection can be displayed.
Note: Subchannel selections
- The new standards employed with digital broadcasting make it possible to receive
multiple program channels under a single major channel number which can be
selected by pressing the digit remote control direct-acces channel number entry.
- The number of channels shown at installation includes paid channels but you
may not be able to see all of them unless you sign up with cable TV operators.
Important:
TV menu Installation
After the installation of the TV channels has been done, always make a selection Franaise
ChannelsInstallation update
in the Installation menu between Antenna or Cable whether you want to watch
AutoprogramAntenna TV channels or Cable TV channels.
Start now If you make use of a signal splitter do not forget to put the switch in the Installation update
corresponding position.
Weak channel installation
Installation update (only with Digital TV broadcasting)Installation mode
This allows you to automatically tune to and update all available digital channels.
Notes: - this will not reinstall uninstalled channels;
- digital channels that are not encountered any longer will be removed;Espaol
- new channels found will not be added to any favorite list;
- already installed channels will not be renumbered.
Weak channel installation
This enables you to do a weak ATSC digital channel installation. This is only
available for TV channels installed via an antenna connection.
& If a certain channel you expect to see is not tuned or is weak, you can install
it manually. Call your local broadcasting station to know what channel its
being transmitted on.
é Select that channel in the displayed list of TV channels (in the antenna mode).
The signal strength is displayed and updated continuously as you rotate the
antenna.
Installation mode
This allows you to select the already stored terrestrial or cable TV channels.
Choose for Antenna or Cable whether these signals are present.
17 |
ACEC
