2147.6 (16x24) 14-03-2003 16:14 Pagina 3
Night mode (only functional with Dolby Digital sound broadcasting input)
The loud parts of the sound are lowered and the soft passages are raised.
You can enjoy surround sound without disturbing sleeping children or neighbours.
Audio only
This control enables you to blank the TV picture if the TV or monitor is used as centre speaker in the
Cinema Link system and if the audio receiver is reproducing sound unrelated to a TV picture.
Switch Audio only On to only hear the sound and to switch off the picture.
The message Audio only appears on screen.
Surround menu
Dependent on the audio receiver speakers configuration, you may not be able to select certain menu
items.
Adjustment of the volume level of the loudspeakers
Surround
Note:the test tone function is automatically cancelled by the audio
Receiver
receiver when leaving the Surround menu.
Test Tone
& Select Test Tone On.
Front left volume
A steady noise tone is switched sequentially through the available
Front right volume
loudspeakers, except for the subwoofer, for 2 seconds each.This
Centre volume
enables you to have a reference of the loudness of each
Rear volumeloudspeaker and to adjust the level of each until they all sound
Rear left volumeequally loud.
Rear right volumeThe loudspeakers activated light up in the screen graphic.
Subwoofer volumeé Select the Surround menu items with the cursor up/down one
after another and alter the selected adjustments with the cursor
left/right.
The best result is achieved when all speakers have equal volume in
your usual listening position.
Ť Select Test tone Off when you have finished the adjustment of the
speaker levels.
Speakers menu
Dependent on the audio receiver speakers configuration, you may not be able to select certain menu
items.
Once the number and position of the loudspeakers has been fixed, selecting Centre speaker, Rear
Speakers and Subwoofer Yes or No, you can adjust the initial receiver settings, size and distance, for
optimal surround sound.
Note:after changing the configuration,the menu will disappear temporarily and re-appear again after the new
settings will be updated.
Size of the speakers
Speakers
Select Small if your speaker is able to reproduce low notes down
Receiver
to at least 80-100 Hz. Select Large if your speaker is able to
Centre speakersYes/No
reproduce low notes down to at least 50 Hz.
Rear speakersYes/No
Note:
Subwoofer presentYes/no- As a rule of thumb,a large speaker has a cone diameter of at least
Front speaker sizeLarge/Small12 cms (5 inches).See the specification sheet of your loudspeakers.
Centre speaker sizeLarge/Small- If Subwoofer present is set to No,Front speaker size can only be set
to Large.If Front speaker size is set to Small,Centre speaker size canRear speaker sizeLarge/Small
only be set to Small and consequently a subwoofer must be
Distance to front1-10 m
connected.
Distance to centre1-10 m
Distance to rear1-10 mDistance to the speakers
Select the distance from your usual listening position to the
available speakers each; front, centre and rear speakers.
This defines the delay time for the surround sound.
3 |
ACEC
