Picture Menu Y The Convergence Control
CONVERGE RED /BLUE
he influence of magnetic fields
Tand changes in the position of the
TVmay cause screen colors not to
line up properly. The result on your
TVscreen will be red or blue colors
appearing around the edges ofPICTURE
images.TINTCONVERGE RED
COLOR TEMPCONVERGE BLUEPICTURE
If various images on the entire picturDNReMULTIPOINT RED CONVERGENCE
IMAGEMAXMULTIPOINT BLUE
have red outlines, adjust the CON-CONVERGE RED
CONVERGENCESAVE MULTIPOINTCONVERGE BLUE
VERGE RED control. Then if any red
MULTIPOINT RED
outlines remain, adjust the MULTI-MULTIPOINT BLUE
SAVE MULTIPOINT
POINTRED control.
If various images on the entire picture
have blue outlines, adjust the CON-
VERGEBLUE control. Then if any
blue outlines remain, adjust the MUL-
TIPOINTBLUE control.CONVERGE RED
7
Use the UNDO MULTIPOINTcontrol
if you want to restore the pictureAVi+SAP
TV
screen to the way it was before youVCR123
made Multipoint adjustments. ACC
456
CONVERGE RED
NOTE: After turning the TV set on,789
1SMARTSMART
allow it to warm up for 15 minutes0
before adjusting the Convergence
MENUSURF2
controls.4
5
BEGIN
Press the MENU button on the6
CHSMART HELP
remote to show the on-screen menu.
PICTURE will be highlighted.You can adjust the CON-
3
INCR. SURR.PIPA/CHVERGE BLUE control the
Press the CURSOR RIGHT but-
same way you would the CON-
ton to enter the PICTURE menu.
VERGE RED control.
PIP CH
Press the CURSOR DOWN but-UPDN
tonrepeatedly until CONVER-
GENCE is selected.
Press the CURSOR RIGHT but-
ton to enter the CONVERGENCE
menu.
Press the CURSOR RIGHT but-PICTURE
CONVERGENCE
tonto enter CONVERGE RED mode.
CONVERGE RED
CONVERGE BLUE
MULTIPOINT RED
Press the CURSOR LEFT,
MULTIPOINT BLUE
CONVERGE BLUECONVERGE BLUE
RIGHT, UP, or DOWN buttontoSAVE MULTIPOINT
adjust the cross image until the color
outline around it is gone.
Press the i+ buttonto exit the
menu from the screen.
9 |
ACEC
